Доступ предоставлен для: Guest
Архив
Proceedings of the 24th National and 2nd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2017)


ISBN Онлайн: 978-1-56700-478-6

CFD ANALYSIS OF HEAT TRANSFER CHARACTERISTICS OF SOLAR COLLECTOR IN REAL SURROUNDING WIND FACTORS

DOI: 10.1615/IHMTC-2017.1920
pages 1391-1396

Ajeet Pratap Singh
Department of Mechanical Engineering, IIT(BHU) Varanasi, 221005, Uttar Pradesh, India

Om Prakash Singh
Department of Mechanical Engineering, Indian Institute of Technology (BHU), Varanasi, Uttar Pradesh, India

Аннотация

This paper is based on the estimation of parameters related to heat losses i.e. temperature, Nusselt number and heat transfer coefficient variation from the surface of flat plate solar collector at different tilt angle of flat plate solar collector (α), wind incidence angle (θ) and wind velocity at windward facing position.
The simulation study carried out in this paper is to analyze the effect of heat transfer on flat plate solar collector by convection mode under the influence of blowing wind in the wind tunnel. The meshing model of collector placed inside the wind tunnel and the basic boundary condition adopted were uniform heat flux boundary condition. Based on the constant heat flux boundary condition, the comparisons were made with the published results in journal for validation purpose. The effect on heat transfer due to some more parameters heat flux (qwm), flat plate collector tilt angle (α) and wind incidence angle (θ) at windward facing positions were captured in this paper. The average convection heat transfer coefficient hcm and average convection Nusselt number Nucm variations with these above mentioned parameters were presented. At different flat plate collector tilt angle (α) greatly effects the average convection heat transfer coefficient hcm and average convection Nusselt number Nucm as well, so the tilt angle of flat plate solar collector is consider as an important parameter. It has been seen that for the small values of α of flat plate collector, Nusselt number is not much sensitive to tilt angle ? at windward facing position. The effect of temperature gradient i.e. difference of temperature of plate and the ambient temperature increases along the height from bottom to top of the flat plate collector in uniform heat flux boundary condition. The effect of natural convection plays an important role in enhancing the heat transfer rate and becomes more effective as associated with Grashof (Gr) dimensionless number, when the air flow would be at lower velocities. The supply of more heat flux at higher velocities of air flow has proven not every time beneficial for Nusselt number to increase, sometimes it only increases the temperature of the flat plate collector, which is not desirable. The result revealed, the tilt angle of a flat plate solar collector plays a very important role during the heat transfer analysis of solar collector.