Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.9

ISSN Печать: 2152-5102
ISSN Онлайн: 2152-5110

Выпуски:
Том 47, 2020 Том 46, 2019 Том 45, 2018 Том 44, 2017 Том 43, 2016 Том 42, 2015 Том 41, 2014 Том 40, 2013 Том 39, 2012 Том 38, 2011 Том 37, 2010 Том 36, 2009 Том 35, 2008 Том 34, 2007 Том 33, 2006 Том 32, 2005 Том 31, 2004 Том 30, 2003 Том 29, 2002 Том 28, 2001 Том 27, 2000 Том 26, 1999 Том 25, 1998 Том 24, 1997 Том 23, 1996 Том 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v30.i5.20
12 pages

Heat Transfer in Thin Liquid Films Utilizing Binary Fluid Mixtures

Rama Subba Reddy Gorla
Department of Mechanical Engineering, Cleveland State University, Cleveland, OH, 44115 USA; Department of Mechanical Engineering, University of Akron, Akron, Ohio 44325, USA; Department of Mechanical & Civil Engineering, Purdue University Northwest, Westville, IN 46391, USA
Santosh Viswanadham
Department of Mechanical Engineering, Cleveland State University Cleveland, Ohio 44115-2425, USA
Asad Salem
Department of Engineering Technology, Cleveland State University Cleveland, Ohio 44115-2425, USA
Larry W. Byrd
Thermal Structures Branch, Air Vehicles Directorate, Air Force Research Laboratory, Wright Patterson Air Force Base, OH 45433, USA

Краткое описание

The objective of the present study is to determine the detailed transport physics of enhanced capillary pumped heat transport concepts utilizing binary fluid mixtures. The introduction of a small amount of a less volatile fluid with a higher surface tension into the working fluid will increase the capillary pumping potential in capillary heat transfer devices. An evaporating thin film was modeled by considering the concentration and thermal gradients. Lubrication theory was used to describe the velocity field by taking interfacial thermocapillary stresses into account. The mass flow rate of evaporation, heat flux and heat transfer coefficient were evaluated for various concentrations of the binary fluid. It is found that there is an optimal concentration of the binary fluid below which the heat transfer rate increases.


Articles with similar content:

Heat Transfer in an Evaporating Extended Meniscus in Capillary Tubes Utilizing Binary Fluid Mixtures
International Journal of Fluid Mechanics Research, Vol.31, 2004, issue 3
Rama Subba Reddy Gorla, Larry W. Byrd
FORCED CONVECTIVE CONDENSATION OF A NONAZEOTROPIC BINARY VAPOR MIXTURE ON VERTICAL AND HORIZONTAL TUBES
International Heat Transfer Conference 9, Vol.4, 1990, issue
Nobuhiro Himeno, Susumu Goto, Kunio Hijikata
THE EFFECT OF MASS TRANSFER ON HEAT TRANSFER RATES FOR TWO-PHASE FLOW IN A VERTICAL PIPE
International Heat Transfer Conference 6, Vol.1, 1978, issue
Т. M. Godbold, S. R. Ravipudi
Linear Stability Analysis of a Liquid-Vapor Interface with Heat and Mass Transfer - Application to Film Boiling
International Heat Transfer Conference 10, Vol.12, 1994, issue
K. Adham-Khodaparast, B. N. Antar, Masahiro Kawaji
ENTRANSY DISSIPATION ANALYSIS OF LIQUID VORTEX ISOLATED BY HOLLOW CYLINDER
Heat Transfer Research, Vol.49, 2018, issue 17
Fikret Alic