Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.5

ISSN Печать: 2152-5102
ISSN Онлайн: 2152-5110

Выпуски:
Том 46, 2019 Том 45, 2018 Том 44, 2017 Том 43, 2016 Том 42, 2015 Том 41, 2014 Том 40, 2013 Том 39, 2012 Том 38, 2011 Том 37, 2010 Том 36, 2009 Том 35, 2008 Том 34, 2007 Том 33, 2006 Том 32, 2005 Том 31, 2004 Том 30, 2003 Том 29, 2002 Том 28, 2001 Том 27, 2000 Том 26, 1999 Том 25, 1998 Том 24, 1997 Том 23, 1996 Том 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v24.i4-6.420
pages 872-883

Time Dividing Analysis of Intermittent Fuel Spray Flows Measured by PDA

Tsuneaki Ishima
Department of Mechanical System Engineering, Gunma University, 1-5-1, Tenjin, Kiryu, 376 Japan
W.-Q. Long
Mechanical Engineering Laboratory, MITI, Tsukuba, Japan
T. Obokata
Department of Mechanical System Engineering, Gunma University, 1-5-1, Tenjin, Kiryu, 376 Japan

Краткое описание

The article presents the analyzing methods for intermittent and cyclic Diesel type- and gasoline type-sprays. The Diesel type sprays were initiated from a single-hole, a four-holes and a conical spray nozzles, and the gasoline type spray was initiated from an air-assisted spray injector. The measurements have been carried out by using phase Doppler anemometer (PDA). A frequency discriminating center part selection method and a temporal dividing method have been proposed for evaluating the intermittent cyclic spray. Using the frequency discrimination method, it was easy to discuss the intermittent spray characteristics with the mean velocity and the velocity fluctuation, and it was also easy to compare the results between those of continuous sprays and/or gas jets. The temporal dividing method was able to explain unusual correlations between droplet size and velocity of the intermittent sprays from both the conical nozzle and the air assisted injector. An accumulation of large particle was observed by using this method in the conical spray.


Articles with similar content:

MEASUREMENTS OF ATOMIZATION QUALITY AND AIR ENTRAINMENT FOR A TRANSIENT DENSE DIESEL FUEL SPRAY
ICLASS 94
Proceedings of the Sixth International Conference on Liquid Atomization and Spray Systems, Vol.0, 1994, issue
M. M. Elkotb, H. A. EI-Salmawy
EXPERIMENTAL INVESTIGATION OF THE ATOMIZATION CHARACTERISTICS OF ANTICORROSION WAX
Atomization and Sprays, Vol.23, 2013, issue 7
Sanghoon Lee, Sungwook Park
Fuel Droplet Dynamics and Dispersion of Practical Twin-Fluid Atomizer for Oil Furnace
International Journal of Fluid Mechanics Research, Vol.24, 1997, issue 1-3
Tsuyoshi Nakajima, Yuji Ikeda, N. Kawahara, Nobutaka Tsuchimoto
NUMERICAL INVESTIGATION OF A STEADY NONEVAPORATING HOLLOW-CONE SPRAY INTERACTING WITH AN ANNULAR AIR JET
Atomization and Sprays, Vol.11, 2001, issue 2
Kang Y. Huh, Woo Tae Kim, Jacob A. Friedman, Metin Renksizbulut
EFFECT OF THE LIQUID INJECTION ANGLE ON THE ATOMIZATION OF LIQUID JETS IN SUBSONIC CROSSFLOWS
Atomization and Sprays, Vol.24, 2014, issue 1
H. Almeida, J. M. M. Sousa, Mário Costa