Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
Multiphase Science and Technology
SJR: 0.183 SNIP: 0.483 CiteScore™: 0.5

ISSN Печать: 0276-1459
ISSN Онлайн: 1943-6181

Выпуски:
Том 32, 2020 Том 31, 2019 Том 30, 2018 Том 29, 2017 Том 28, 2016 Том 27, 2015 Том 26, 2014 Том 25, 2013 Том 24, 2012 Том 23, 2011 Том 22, 2010 Том 21, 2009 Том 20, 2008 Том 19, 2007 Том 18, 2006 Том 17, 2005 Том 16, 2004 Том 15, 2003 Том 14, 2002 Том 13, 2001 Том 12, 2000 Том 11, 1999 Том 10, 1998 Том 9, 1997 Том 8, 1994 Том 7, 1993 Том 6, 1992 Том 5, 1990 Том 4, 1989 Том 3, 1987 Том 2, 1986 Том 1, 1982

Multiphase Science and Technology

DOI: 10.1615/MultScienTechn.2019029434
pages 45-59

EXPERIMENTAL INVESTIGATION OF HYDRODYNAMICS BEHAVIOR OF A SUBMERGED VENTURI SCRUBBER

Paridhi Goel
Homi Bhabha National Institute, Anushakti Nagar, Mumbai 400094, Maharashtra, India; Reactor Engineering Division, Bhabha Atomic Research Centre, Mumbai 400085, Maharashtra, India
Avinash Moharana
Reactor Engineering Division, Bhabha Atomic Research Centre, Mumbai 400085, Maharashtra, India
Arun Kumar Nayak
Homi Bhabha National Institute, Anushakti Nagar, Mumbai 400094, Maharashtra, India; Reactor Engineering Division, Bhabha Atomic Research Centre, Mumbai-400085, India

Краткое описание

An experimental study was conducted in a submerged Venturi scrubber having full-scale geometrical dimensions as the prototype reactor. The experiments were carried out at various pressure conditions, air flow rate, and submergence heights to simulate the hydrodynamics of a Venturi scrubber. Measurements of two-phase axial pressure drop in the Venturi scrubber were made across a wide range of operating all the conditions. In all conditions, the pressure drop increased with increase in flow rate in the converging section and in the throat section after the entrainment of liquid in the nozzles. However, in low pressure conditions in the diverging section was not recovered, unlike the high pressure conditions in previous measurements. The Venturi scrubber performance depends on the radial pressure difference across the nozzles located between the scrubbing pool and the throat of the Venturi, which creates liquid entrainment. The sizes and numbers of these droplets influence the scrubbing. The radial pressure difference between the Venturi throat and the scrubber tank at the nozzles across the throat was more for higher submergence height (4.5 m) as compared to lower submergence height (4 m), and it decreased with increase in gas flow rate in the Venturi scrubber. A theoretical estimation of the liquid loading to the Venturi scrubber was made from the radial pressure difference measured across nozzles. From the calculated liquid loading and the gas flow rate as input, the pressure drop across the Venturi scrubber was calculated using the models proposed by Calvert, Boll, and Hesketh. These calculated values did not correlate well with the experimental results.

ЛИТЕРАТУРА

  1. Ali, M., Changqi, Y., Zhongning S., Haifeng, G., Junlong,W., and Mehboob, K., Iodine Removal Efficiency in Non-Submerged and Submerged Self-Priming Venturi Scrubber, Nucl. Eng. Technol., vol. 45, no. 2, pp. 203–210, 2013.

  2. Allen, R.W.K. and Santen, A., Designing for Pressure Drop in Venturi Scrubbers: The Importance of Dry Pressure Drop, Chem. Eng. J. Biochem. Eng. J., vol. 61, no. 3, pp. 203–211, 1996.

  3. Azzopardi, B. and Govan, A.H., The Modeling of Venturi Scrubbers, Filtration Separation, vol. 21, no. 3, pp. 196–200, 1984.

  4. Boll, R.H., Particle Collection and Pressure Drop in Venturi Scrubbers, Industrial Eng. Chem. Fund., vol. 12, no. 1, pp. 40–50, 1973.

  5. Calvert, S., Venturi and Other Atomizing Scrubbers Efficiency and Pressure Drop, AIChE J., vol. 16, no. 3, pp. 392–396, 1970.

  6. Gamisans, X., Sarr`a, M., Lafuente, F.J., and Azzopardi, B.J., The Hydrodynamics of Ejector-Venturi Scrubbers and Their Modelling by an Annular Flow Boundary Layer Model, Chem. Eng. Sci., vol. 57, no. 14, pp. 2707–2718, 2002.

  7. Goel, K.C. and Hollands, K.G.T., A General Method for Predicting Particle Collection Efficiency of Venturi Scrubbers, Industrial Eng. Chem. Fund., vol. 16, no. 2, pp. 186–193, 1977.

  8. Guerra, V., Bettega, R., Gonc¸alves, J.A.S., and Coury, J.R., Pressure Drop and Liquid Distribution in a Venturi Scrubber: Experimental Data and CFD Simulation, Industrial Eng. Chem. Res., vol. 51, no. 23, pp. 8049–8060, 2012.

  9. Haller, H., Muschelknautz, E., and Schultz, T., Venturi Scrubber Calculation and Optimization, Chem. Eng. Technol., vol. 12, no. 1, pp. 188–195, 1989.

  10. Hesketh, H.E., Atomization and Cloud Behavior in Venturi Scrubbing, J. Air Pollution Control Assoc., vol. 23, no. 7, pp. 600–604, 1973.

  11. Horiguchi, N., Yoshida, H., Uesawa, S., Kaneko, A., and Abe, Y., Research and Development of Self- Priming Venturi Scrubber for Filter Venting: Preliminary Analysis and Observation of Hydraulic Behavior in Venturi Scrubber, ICONE-21, Proc. of the 2013 21st International Conference on Nuclear Engineering, Chengdu, China.

  12. Jacquemain, D., Guentay, S., Basu, S., Sonnenkalb, M., Lebel, L., Allelein, H.J., Martinez, B.L., Eckardt, B., and Ammirabile, L., OECD/NEA/CSNI Status Report on Filtered Containment Venting, Rep. NEA-CSNI-R-2014-7, 2014.

  13. Lehner, M., Aerosol Separation Efficiency of a Venturi Scrubber Working in Self-Priming Mode, Aerosol Sci. Technol., vol. 28, no. 5, pp. 389–402, 1998.

  14. Lindau, L., FILTRA-MVSS, A System for Reactor Accidents Mitigation, J. Aerosol Sci., vol. 19, no. 7, pp. 1389–1392, 1988.

  15. McCabe, W., Smith, J., and Harriott, P., Unit Operations of Chemical Engineering, 6th ed., New York: McGraw-Hill International Edition, p. 118, 2001.

  16. Nukiyama, S. and Tanasawa, Y., An Experiment on the Atomisation of Liquid by Means of an Air Stream, Trans. Japan Soc. Mech. Eng., vol. 4, no. 15, pp. 138–143, 1938.

  17. Rust, H., T¨annler, Ch., Heintz, W., Haschke, D., Nuala, M., and Jakab, R., Pressure Release of Containments during Severe Accidents in Switzerland, Nuclear Eng. Design, vol. 157, no. 3, pp. 337–352, 1995.

  18. Silva, A.M., Teixeira, J.C.F., and Teixeira, S.F.C.F., Experiments in a Large-Scale Venturi Scrubber Part I: Pressure Drop, Chem. Eng. Proc.: Proc. Intensif., vol. 48, no. 1, pp. 59–67, 2009.

  19. Vishwanathan, S., Gnyp, A.W., and St. Pierre, C.C., Annular Flow Pressure Drop Model for Pease-Anthony Type Venturi Scrubbers, AIChE J., vol. 31, no. 12, pp. 1947–1958, 1985.


Articles with similar content:

EXPERIMENTAL INVESTIGATION OF THE EFFECT OF BYPASS AIR ON BORON COMBUSTION IN A SOLID FUEL RAMJET
International Journal of Energetic Materials and Chemical Propulsion, Vol.2, 1993, issue 1-6
David W. Netzer, Benveniste Natan
Characteristic Behavior of Boiling Bubble Initiation Under High Pressure Conditions
International Heat Transfer Conference 15, Vol.38, 2014, issue
Keisuke Yasumi, Sayaka Akiyama, Seiichi Yokobori
FUEL DISINTEGRATION IN GAS ATOMIZERS
ICHMT DIGITAL LIBRARY ONLINE, Vol.5, 1997, issue
Y.M. Shtemler, Michael P. Levitsky, Y. Berkovich
EXPERIMENTAL INVESTIGATION OF GEOMETRIC SCALING ON ATOMIZATION IN A TWO-PHASE GAS/LIQUID SPRAY
Multiphase Science and Technology, Vol.22, 2010, issue 2
Alidad Amirfazli, Mohammad Azizur Rahman, C. E. Ejim, Brian A. Fleck
FORMATION AND OXIDATION OF SOOT PARTICULATES IN A DIESEL FUEL SPRAY FLAME
International Journal of Energy for a Clean Environment, Vol.7, 2006, issue 1
R. J. Crookes, G. Sivalingam