Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN Печать: 2150-766X
ISSN Онлайн: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v4.i1-6.800
pages 863-875

THE RESPONSE OF A PYROTECHNIC POWDER UNDER DYNAMIC LOADING CONDITIONS

Alice I. Atwood
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100 USA
C. F. Price
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100 USA
S. A. Finnegan
Naval Air Warfare Center Weapons Division.China Lake, CA 93555-6001
P. O. Curran
Naval Air Warfare Center Weapons Division.China Lake, CA 93555-6001
J. Wiknich
Sverdrup INS Aegir. Ridgecrest, CA 93555

Краткое описание

Experimental and analytical results describing the combustion response of a porous pyrotechnic powder under dynamic loading conditions are described. Pyrotechnic powder samples were subjected to dynamic loading using a piston driven porous bed configuration. Piston impact velocities ranged from about 80 to 300 m/sec. The initial loading density of the porous bed ranged from 54 to 56 percent of theoretical maximum density (TMD). The porous bed of pyrotechnic material ignited and burned at all but the lowest impact velocity tested (81 m/sec) where no reaction was observed. Two impact velocity dependent combustion modes were observed in the high speed motion pictures. No accelerating reactions were observed in either the motion pictures or the pressure gage data for the conditions tested. Traditional analytical porous bed combustion techniques were used in the evaluation of the pyrotechnic response under dynamic loading conditions. The NWCDDT porous bed code was used to model the response of the pyrotechnic power to mechanical stimulus. Calculations of the pyrotechnic powder were complicated by the rebounding of the initial compaction wave off of the end of the confining tube.


Articles with similar content:

RECENT DEVELOPMENTS IN GUN PROPELLANTS AND GUN PROPULSION RESEARCH AT S.N.P.E.
International Journal of Energetic Materials and Chemical Propulsion, Vol.4, 1997, issue 1-6
Jean-Paul Reynaud
RECYCLING PROPELLANTS AND EXPLOSIVES INTO THE COMMERCIAL EXPLOSIVE INDUSTRY
International Journal of Energetic Materials and Chemical Propulsion, Vol.4, 1997, issue 1-6
Paul L. Miller, Mark E. Morgan
BURNING RATE STUDIES OF BIS-TRIAMINOGUANIDINIUM AZOTETRAZOLATE (TAGzT) AND HEXAHYDRO-1,3,5-TRINITRO-1,3,5-TRIAZINE (RDX) MIXTURES
International Journal of Energetic Materials and Chemical Propulsion, Vol.8, 2009, issue 1
Steven F. Son, Bryce C. Tappan, Joseph M. Lloyd, Benjamin Aaron Mason
CONVECTIVE BURNING STUDIES OF PYROTECHNIC POWDERS
International Journal of Energetic Materials and Chemical Propulsion, Vol.9, 2010, issue 5
Alice I. Atwood, C. J. Wheeler, P. O. Curran, J. F. Moxnes, S. A. Baynar, K. P. Ford, G. Odegardstuen
NONLINEAR COMBUSTION IN SOLID PROPELLANT ROCKET MOTORS
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
B. V. Novozhilov