Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN Печать: 2150-766X
ISSN Онлайн: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v4.i1-6.660
pages 706-718

POLYNIMMO, A CANDIDATE BINDER FOR SOLID FUEL GAS GENERATOR PROPELLANTS

P. J. Honey
WX4 Department, Defence Research Agency, Fort Halstead, Sevenoaks, Kent, TN14 7BP, England
D. W. Anderson
WX4 Department, Defence Research Agency, Fort Halstead, Sevenoaks, Kent, TN14 7BP, England
G. A. Spinks
WX4 Department, Defence Research Agency, Fort Halstead, Sevenoaks, Kent, TN14 7BP, England
A. V. Cunliffe
WX4 Department, Defence Research Agency, Fort Halstead, Sevenoaks, Kent, TN14 7BP, England
D. A. Tod
WX4 Department, Defence Research Agency, Fort Halstead, Sevenoaks, Kent, TN14 7BP, England

Краткое описание

An investigation of polyNIMMO's potential, as both binder and oxidiser, in a high energy smokeless solid fuel gas generator propellant comprised part of a UK ramrocket development programme. The benchmark trial showed polyNIMMO's burn rate was considerably lower than GAP, or polyGLYN. The advantages and disadvantages of various binary mixtures of polyNIMMO with fuels, oxidisers, plasticisers and bum rate catalysts are discussed. The conclusions drawn from this study were applied to multiple component polyNIMMO formulations, with volumetric heat values of up to 32200 MJ/m3 (∼500 Btu/in3). Difficulties with ignitability of fuel-rich systems were observed. Comparison of the chamber temperature (which varied, significantly, with pressure) with the burn rate proved to be a more suitable method for assessment of ignitability than the formulations temperature of ignition. The relationship observed between the calculated chamber temperature and experimental burn rate will be discussed in greater detail. This work has shown that the smokeless fuel-rich polyNIMMO gas generator compositions examined possess the basic characteristics required for an air-breathing radial-burner motor configuration. Effort is currently focused on achieving a smokeless fuel-rich formulation (≈32200 MJ/m3) possessing a high pressure exponent (∼0.5-0.7) with a slow, stable, bum rate (∼0.7 mm/s) at low pressure (<3 MPa).


Articles with similar content:

STUDIES ON BORON/ALUMINUM DODECABORIDE (AlB12)–BASED NOVEL IGNITER COMPOSITION
International Journal of Energetic Materials and Chemical Propulsion, Vol.17, 2018, issue 2
Anurag Tripathi, Sukeshni Rawal, Seema Dilip Kakade, Pawan Kumar Khanna, Manasa Kumar Das
COMBUSTION OF GELLED RP-1 PROPELLANT WITH ALEX® PARTICLES IN GASEOUS OXYGEN ATOMIZED SPRAYS
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
Frederick Tepper, J. W. Mordosky, George C. Harting, L. A. Kaledin, Baoqi Zhang
BURN RATE STUDEES OF GAS GENERATOR PROPELLANTS CONTAINING AP/RDX
International Journal of Energetic Materials and Chemical Propulsion, Vol.4, 1997, issue 1-6
A. N. Nazare, Haridwar Singh, S. N. Asthana, P. G. Shrotri
COMBUSTION BEHAVIOR AND THERMOCHEMICAL PROPERTIES OF JA2 PROPELLANT
International Journal of Energetic Materials and Chemical Propulsion, Vol.4, 1997, issue 1-6
Stefan T. Thynell, C. Kopicz, T. J. Watson
INVESTIGATION OF SOLID OXIDIZER AND GASEOUS FUEL COMBUSTION PERFORMANCE USING AN ELEVATED PRESSURE COUNTERFLOW EXPERIMENT FOR REVERSE HYBRID ROCKET ENGINE
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 6
Grant A. Risha, Terrence L. Connell, Jr., Reed H. Johansson, Gregory Young, Richard A. Yetter