Доступ предоставлен для: Guest
Портал Begell Электронная Бибилиотека e-Книги Журналы Справочники и Сборники статей Коллекции
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN Печать: 2150-766X
ISSN Онлайн: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v4.i1-6.340
pages 337-344

INSENSITIVE MUNITIONS PROPULSION PROGRESS

S. C. DeMay
Naval Air Warfare Center Weapons Division, China Lake, USA
C. J. Thelen
Sverdrup Technology, Inc., NAWC Division, USA

Краткое описание

Increasing interest in the application of thrust-managed, solid-propellant rocket motors for future missiles has prompted a desire to learn how these motors might react to the stimuli involved in the MIL-STD 2105B1 insensitive munitions (IM) hazards tests. An opportunity became available for the Insensitive Munitions Advanced Development (IMAD) Propulsion Project to obtain four experimental, dual-pulse (two chamber) rocket motors; these motors were subjected to the fast cookoff, slow cookoff, bullet impact, and fragment impact IM hazards tests. These motors had steel cases with a bulkhead separating one pulse from the other. The propellant for each pulse grain was a nitrate-ester-plasticized, reduced-smoke, hydroxyl-terminated polyether (HTPE) propellant.
Reactions in the IM hazards tests were classified as follows: fast cookoff, deflagration (fail); slow cookoff, explosion (fail); bullet impact, burn (pass); and fragment impact, explosion (fail). In the cookoff tests, the aft pulse (pulse 1) reacted first followed by the forward pulse (pulse 2). Delay times between the reaction of pulse 1 and pulse 2 were 5 seconds for the fast cookoff and 45 seconds for the slow cookoff tests. It was unexpected when pulse 1 reacted first, because this pulse's chamber consisted of thicker insulation. In the impact tests, the projectiles and fragments were aimed at the pulse 2 chamber resulting in the reaction of this pulse with no accompanying reaction from pulse 1. The implication of these results is that separate chamber, pulsed motors containing a relatively insensitive propellant such as the HTPE propellant will probably provide less collateral damage than motors in which an equivalent amount of propellant is contained in one chamber.


Articles with similar content:

BURNING-RATE CHARACTERISTICS OF BORON/[BAMO/NMMO] FUEL-RICH SOLID PROPELLANT UNDER BROAD RANGES OF PRESSURE AND TEMPERATURE
International Journal of Energetic Materials and Chemical Propulsion, Vol.2, 1993, issue 1-6
W. H. Hsieh, I. T. Huang, A. S. Yang
AMMONIUM DINITRAMIDE/GLYCIDYL AZIDE POLYMER (ADN/GAP) COMPOSITE PROPELLANTS WITH AND WITHOUT METALLIC FUELS
International Journal of Energetic Materials and Chemical Propulsion, Vol.16, 2017, issue 1
Volker Gettwert, Luigi T. DeLuca, Volker Weiser, Andrea Franzin, Manfred A. Bohn
ENVIRONMENT-FRIENDLY COMPOSITE PROPELLANTS BASED ON AMMONIUM DINITRAMIDE
International Journal of Energetic Materials and Chemical Propulsion, Vol.18, 2019, issue 1
Claudio Tagliabue, Volker Weiser, Volker Gettwert, Sven Hafner, Sebastian Fischer
MANUFACTURING AND TESTING OF A DUAL-PROPELLANT NOZZLELESS BOOSTER TECHNOLOGY DEMONSTRATOR
International Journal of Energetic Materials and Chemical Propulsion, Vol.8, 2009, issue 6
Martin Hubinger, Gideon J. van Zyl
FRENCH AND GERMAN TEST METHODS TO CHARACTERIZE LOW SENSITIVE GUN PROPELLANTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.6, 2007, issue 3
Gert Pauly, C. Reynaud, Barbara Baschung, S. Schaefer, D. Grune