Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
TsAGI Science Journal

ISSN Imprimir: 1948-2590
ISSN On-line: 1948-2604

TsAGI Science Journal

DOI: 10.1615/TsAGISciJ.2017021109
pages 141-158

CHOICE AND DESIGN OF A 3D FIXED-GEOMETRY INLET FOR A SMALL SUPERSONIC BUSINESS AIRCRAFT

Vyacheslav Afanasievich Vinogradov
Central Institute of Aviation Motors (CIAM), 2 Aviamotornaya Str., Moscow, 111116, Russian Federation
Yakov Aleksandrovich Melnikov
Central Institute of Aviation Motors (CIAM), 2, Aviamotornaya Str., Moscow, 111116 Russia
Vladimir Alekseevich Stepanov
Central Institute of Aviation Motors (CIAM), 2 Aviamotornaya Str., Moscow, 111116, Russian Federation

RESUMO

The scheme and geometric dimensions of a three-dimensional (3D) self-starting fixed-geometry inlet of a supersonic business aircraft at a cruise flight speed of Mcr = 1.8 are chosen. Two variants of inlet positioning on the airframe are considered: (1) with ingestion of the boundary layer growing on the fuselage forebody and (2) with spillage of the boundary layer by mounting the inlet at a certain height above the fuselage surface. The flow over the inlet integrated with the airframe of the supersonic business aircraft is calculated by the FASTRAN software based on integration of the system of steady Reynolds-averaged Navier–Stokes equations, which uses an implicit scheme to describe the spatial flows of a viscous compressible perfect gas settling over time at constant specific heat in a Cartesian coordinate system. As a result, the local parameters of the flow along the inlet duct are obtained. The integral inlet performance (flow rate coefficient φ and total pressure loss σ along the inlet duct and at the subsonic diffuser exit) is also estimated. In order to enhance the integrated characteristics of the inlet and increase the range of stable operation of the inlet in throttling regimes, a system of boundary layer control is applied in the region of supersonic deceleration that bypasses some of the air through windows in the corner zones on the side walls (cheeks) and bleeds through slots in the throat region.


Articles with similar content:

EXPERIMENTAL INVESTIGATION OF A 3D FIXED-GEOMETRY INLET FOR A SUPERSONIC BUSINESS AIRCRAFT
TsAGI Science Journal, Vol.48, 2017, issue 3
Vladimir Alekseevich Stepanov, A. Yu. Makarov, N. A. Melkonyan, Vyacheslav Afanasievich Vinogradov
INVESTIGATION OF CHARACTERISTIC PROPERTIES OF FLOWS IN DUCTS DURING INTERFERENCE BETWEEN PERTURBATIONS AND PSEUDO-SHOCK
TsAGI Science Journal, Vol.43, 2012, issue 6
Natalya Valeryevna Guryleva, Valeriy Ivanovich Timoshenko, Mikhail Anatolyevich Ivan'kin, Dmitry Aleksandrovich Lapinsky
INTACT FLOW OVER A ROTATING BODY WITH THE NOSE PART IN THE FORM OF THE RIABOUCHINSKY HALF-CAVITY
TsAGI Science Journal, Vol.48, 2017, issue 3
E. N. Kuznetsov, V. Yu. Lunin, A. V. Panyushkin, I. L. Chernyshev
INVESTIGATION OF LOW-HIGH SPEED COMPRESSIBLE FLOW OVER A ROUND CAVITY
Proceedings of the 24th National and 2nd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2017), Vol.0, 2017, issue
K. Muraleedharan Nair, G. Balu , S. Vishnu Prasad, Krishna V. Gopal
CHARACTERISTICS INVESTIGATION OF 2D AND 3D INTAKES OF SUPERSONIC PASSENGER AIRCRAFT
TsAGI Science Journal, Vol.46, 2015, issue 2
Vladimir Alekseevich Stepanov, Yakov Aleksandrovich Melnikov, Vyacheslav Afanasievich Vinogradov