Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Heat Transfer Research
Fator do impacto: 0.404 FI de cinco anos: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN Imprimir: 1064-2285
ISSN On-line: 2162-6561

Volumes:
Volume 50, 2019 Volume 49, 2018 Volume 48, 2017 Volume 47, 2016 Volume 46, 2015 Volume 45, 2014 Volume 44, 2013 Volume 43, 2012 Volume 42, 2011 Volume 41, 2010 Volume 40, 2009 Volume 39, 2008 Volume 38, 2007 Volume 37, 2006 Volume 36, 2005 Volume 35, 2004 Volume 34, 2003 Volume 33, 2002 Volume 32, 2001 Volume 31, 2000 Volume 30, 1999 Volume 29, 1998 Volume 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.2019026068
pages 1205-1229

NUMERICAL STUDY OF AIR-ATOMIZED WATER MIST COOLING OF A HEATED FLAT PLATE

Vikash Kumar Singh Chauhan
Department of Mechanical Engineering, National Institute of Technology, Manipur, Imphal, Manipur 795004, India
Dushyant Singh
Department of Mechanical Engineering, National Institute of Technology, Manipur, Imphal, Manipur 795004, India
Dr. Singh works in a general area of fluid flow and heat transfer with a focus on understanding the flow physics and heat transfer characteristics of the complex problem in advanced industry problem, along with experimentally and numerically of interest.

RESUMO

The present numerical study describes the phenomena of impingement cooling of a heated fl at surface by air and water mist-jet for mass loading fraction ƒ = 0.003−0.024 at Redhyd = 4500 and h/d = 5. A multiphase two-dimensional axisymmetric, incompressible and turbulent flow is considered in the present study. The results obtained using the standard k−ε, standard k−ω, RNG k−ε, realizable k−ε, and SST k−ω turbulence models were analyzed and discussed. The predictions of the local heat transfer coefficient show that the realizable k−ε turbulence model predicts heat transfer results better than other turbulence models. The comparative study was performed to select a suitable multiphase model among the volume of fluid, mixture, and Eulerian models. The Eulerian multiphase model predicts heat transfer from mist-jet impingement on a flat surface much better than the volume of fluid and mixture multiphase models. Normalized axial and radial velocities of the continuous and dispersed phase are presented to understand the fluid flow. The present numerical study also discusses turbulent kinetic energy near the nozzle exit and volume fraction over the heated flat surface.

Referências

  1. Agrawal, C., Lyons, O.F., Kumar, R., Gupta, A., and Murray, D.B., Rewetting of a Hot Horizontal Surface through Mist Jet Impingement Cooling, Int. J. Heat Mass Transf., vol. 58, nos. 1-2, pp. 188-196, 2013.

  2. Chan, W.T. and Ko, N.W.M., Coherent Structures in the Outer Mixing Region of Annular Jets, J. Fluid Mech., vol. 89, no. 3, pp. 515-533, 1978.

  3. Downs, S. and James, E.H., Jet Impingement Heat Transfer-A Literature Survey, in ASME, AIChE and ANS, 24th National Heat Transf. Conf. Exhibition, 1987.

  4. Dutta, R., Dewan, A., and Srinivasan, B., Comparison of Various Integration to Wall, no. ITW RANS Models for Predicting Turbulent Slot Jet Impingement Heat Transfer, Int. J. Heat Mass Transf., vol. 65, pp. 750-764, 2013.

  5. Feng, L.H., Wang, J.J., and Pan, C., Proper Orthogonal Decomposition Analysis of Vortex Dynamics of a Circular Cylinder under Synthetic Jet Control, Phys. Fluids, vol. 23, no. 1, p. 014106, 2011.

  6. Fu, W.S. and Yang, G.C., Influence of Droplets' Trajectories and Size Distribution on Heat Transfer from a Wedge in an Air- Water Mist Flow, Numer. Heat Transf., vol. 16, no. 2, pp. 155-174, 1989.

  7. Graham, K.M. and Ramadhyani, S., Experimental and Theoretical Studies of Mist Jet Impingement Cooling, J. Heat Transf., vol. 118, no. 2, pp. 343-349, 1996.

  8. Horacek, B., Kiger, K.T., and Kim, J., Single Nozzle Spray Cooling Heat Transfer Mechanisms, Int. J. Heat Mass Transf., vol. 48, no. 8, pp. 1425-1438, 2005.

  9. Hrycak, P., Heat Transfer from Impinging Jets. A Literature Review, Newark, NJ: New Jersey Institute of Technology, 1981.

  10. Jambunathan, K., Lai, E., Moss, M.A., and Button, B.L., A Review of Heat Transfer Data for Single Circular Jet Impingement, Int. J. Heat Fluid Flow, vol. 13, no. 2, pp. 106-115, 1992.

  11. Jia, W. and Qiu, H.H., Experimental Investigation of Droplet Dynamics and Heat Transfer in Spray Cooling, Exp. Therm. Fluid Sci., vol. 27, no. 7, pp. 829-838, 2003.

  12. Kanamori, A., Hiwada, M., Mimatsu, J., Sugimoto, H., and Oyakawa, K., Control of Impingement Heat Transfer Using Mist, J. Therm. Sci. Technol., vol. 4, no. 2, pp. 202-213, 2009.

  13. Kheirabadi, A.C. and Groulx, D., Cooling of Server Electronics: A Design Review of Existing Technology, Appl. Therm. Eng., vol. 105, pp. 622-638, 2016.

  14. Kim, J., Spray Cooling Heat Transfer: The State of the Art, Int. J. Heat Fluid Flow, vol. 28, no. 4, pp. 753-767, 2007.

  15. Li, X., Gaddis, J.L., and Wang, T., Modeling of Heat Transfer in a Mist/Steam Impinging Jet, J. Heat Transf., vol. 123, no. 6, pp. 1086-1092, 2001.

  16. Martin, H., Heat and Mass Transfer between Impinging Gas Jets and Solid Surfaces, Adv. Heat Transf., vol. 13, pp. 1-60, 1977.

  17. Pais, M.R., Chow, L.C., and Mahefkey, E.T., Surface Roughness and Its Effects on the Heat Transfer Mechanism in Spray Cooling, J. Heat Transf., vol. 114, no. 1, pp. 211-219, 1992.

  18. Pakhomov, M.A. and Terekhov, VI., Enhancement of an Impingement Heat Transfer between Turbulent Mist Jet and Flat Surface, Int. J. Heat Mass Transf., vol. 53, nos. 15-16, pp. 3156-3165, 2010.

  19. Pakhomov, M.A. and Terekhov, VI., The Effect of Confinement on the Flow and Turbulent Heat Transfer in a Mist Impinging Jet, Int. J. Heat Mass Transf., vol. 54, nos. 19-20, pp. 4266-4274, 2011.

  20. Patankar, S., Numerical Heat Transfer and Fluid Flow, Boca Raton, FL: CRC Press, 1980.

  21. Patte-Rouland, B., Danlos, A., and Rouland, E., Measurement of the 3D Turbulent Flow Field of an Annular Jet and Proper Orthogonal Decomposition Analysis, in 3rd Int. Conf. Fluid Mechanics Heat Mass Transfer, FLUIDS-HEAT'12, pp. 57-62, 2012.

  22. Quinn, C., Murray, D.B., and Persoons, T., Heat Transfer Behavior of a Dilute Impinging Air-Water Mist Jet at Low Wall Temperatures, Int. J. Heat Mass Transf., vol. 111, pp. 1234-1249, 2017.

  23. Singh, D., Premachandran, B., and Kohli, S., Numerical Simulation of the Jet Impingement Cooling of a Circular Cylinder, Numer. Heat Transf., Part A: Applications, vol. 64, no. 2, pp. 153-185, 2013a.

  24. Singh, D., Premachandran, B., and Kohli, S., Experimental and Numerical Investigation of Jet Impingement Cooling of a Circular Cylinder, Int. J. Heat Mass Transf., vol. 60, pp. 672-688, 2013b.

  25. Sozbir, N., Chang, Y.W., and Yao, S.C., Heat Transfer of Impacting Water Mist on High Temperature Metal Surfaces, J. Heat Transf., vol. 125, no. 1, pp. 70-74, 2003.

  26. Vasquez, S., A Phase Coupled Method for Solving Multiphase Problems on Unstructured Mesh, in ASME 200 Fluids Engineering Division Summer Meeting, 2000.

  27. Vouros, A., Vouros, A., and Panidis, T., Experimental Study of a Water-Mist Jet Issuing Normal to a Heated Flat Plate, Thermal Sci., vol. 20, no. 2, pp. 473-482, 2016.

  28. Yang, J., Chow, L.C., and Pais, M.R., Nucleate Boiling Heat Transfer in Spray Cooling, J. Heat Transf., vol. 118, no. 3, pp. 668-671, 1996.


Articles with similar content:

Thermal-hydraulic analysis of flow in rib-roughened passages with application to gas-cooled nuclear reactors
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2009, issue
Amir Keshmiri, Yacine Addad, Mark A. Cotton, Dominique R. Laurence
Flat Plate Film Cooling Performance Predictions by RANS Turbulence Models
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2012, issue
S. Inanli, Tuba Okutucu-Ozyurt, O. Uzol, I. Gorgulu
AN EXPERIMENTAL AND NUMERICAL STUDY OF FLOW AND HEAT TRANSFER IN RIBBED CHANNELS WITH LARGE RIB PITCH-TO-HEIGHT RATIOS
Journal of Enhanced Heat Transfer, Vol.20, 2013, issue 4
Bengt Sunden, Gongnan Xie, Zahra Ghorbani-Tari, Shian Li
A NUMERICAL STUDY ON THE EFFECTS OF ANISOTROPIC TURBULENCE ON THE BEHAVIORS OF IMPINGING SPRAYS
Atomization and Sprays, Vol.17, 2007, issue 2
Gwon Hyun Ko, Hong Sun Ryou
A CORRELATION FOR BOUNDARY LAYER HEAT TRANSFER ACCOUNTING FOR FREE STREAM TURBULENCE
International Heat Transfer Conference 9, Vol.3, 1990, issue
Robert J. Moffat, Paul K. Maciejewski