Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Heat Transfer Research
Fator do impacto: 0.404 FI de cinco anos: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN Imprimir: 1064-2285
ISSN On-line: 2162-6561

Volumes:
Volume 50, 2019 Volume 49, 2018 Volume 48, 2017 Volume 47, 2016 Volume 46, 2015 Volume 45, 2014 Volume 44, 2013 Volume 43, 2012 Volume 42, 2011 Volume 41, 2010 Volume 40, 2009 Volume 39, 2008 Volume 38, 2007 Volume 37, 2006 Volume 36, 2005 Volume 35, 2004 Volume 34, 2003 Volume 33, 2002 Volume 32, 2001 Volume 31, 2000 Volume 30, 1999 Volume 29, 1998 Volume 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.2016011566
pages 191-209

EXPERIMENTAL AND CFD INVESTIGATION OF LIQUID FLOW OUTSIDE EVAPORATION TUBES AND ITS INFLUENCE ON HEAT TRANSFER

Chunhua Qi
Institute of Seawater Desalination & Multipurpose Utilization, SOA, Tianjin 300192, China
Houjun Feng
Institute of Seawater Desalination & Multipurpose Utilization, SOA, Tianjin 300192, China
Qingchun Lv
Institute of Seawater Desalination & Multipurpose Utilization, SOA, Tianjin 300192, China
Yulei Xing
Institute of Seawater Desalination & Multipurpose Utilization, SOA, Tianjin 300192, China
Ming Zhang
Institute of Seawater Desalination & Multipurpose Utilization, SOA, Tianjin 300192, China

RESUMO

Liquid film flow significantly affects distillation, which directly determines the heat transfer coefficient. This study investigates the effects of flow patterns, as well as of heat and mass transfer on the vapor−liquid interface, on the heat transfer in a horizontal-tube falling-film evaporator. Related data are acquired through simulation and experiment. A volume of fluid model coupled with a user-defined function module was adopted to simulate a liquid−vapor system. In addition, an experimental apparatus and its principal characteristics were introduced. This method was used to test the extended droplets on the tube surface, the flow patterns, and the effect of liquid film state on heat transfer. Simulation results show good agreement with the experimental results, with both having a deviation band within 10%. A computational method suitable for simulating liquid−steam flow is established. Both simulation and experimental results indicate that 0.08 kg/(m·s) of sprinkling density is the breakpoint of liquid outside a tube from columnar flow to sheet flow, and the overall coefficient of heat transfer K under the experimental conditions reaches up to 4.06 kW/m2·K. This value is significant in guiding the design of the spraying density of low-temperature multieffect seawater desalination devices. Thus, this research provides a basis for the further improvement of heat transfer performance.


Articles with similar content:

Single-phase Flow Thermal Performance Characteristics of a Parallel MicroChannel Heat Exchanger
Journal of Enhanced Heat Transfer, Vol.6, 1999, issue 5
M. K. Drost, T. S. Ravigururajan
INTERMITTENT LOW MASS FLUX SPRAY COOLING AT HIGH TEMPERATURE: A NOVEL METHODOLOGY FOR THE AUGMENTATION OF HEAT FLUX IN TRANSITION BOILING REGIME
Journal of Enhanced Heat Transfer, Vol.26, 2019, issue 5
Soumya S. Mohapatra, Basudeb Munshi, Lily
A THEORETICAL CALCULATION OF HEAT TRANSFER DURING DROPWISE CONDENSATION
International Heat Transfer Conference 11, Vol.17, 1998, issue
Dunqi Xu, Yongji Song, Fang Ji Lin
HEAT AND MASS TRANSFER AND RESISTANCE CHARACTERISTICS OF EVAPORATIVE AIR COOLER WITH HIGH FINNED-TUBE BUNDLES
Heat Transfer Research, Vol.49, 2018, issue 17
Zilong Liu, Qinzhu Chen, Qing Zhang, Weicheng Ruan, Xuesheng Wang
THE EFFECT OF HEATING DIRECTION ON FLOW BOILING HEAT TRANSFER OF R134A IN MICRO-CHANNELS
Second Thermal and Fluids Engineering Conference, Vol.20, 2017, issue
Xu Mingchen, Peng Qi, Jia Li, Dang Chao