Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN Imprimir: 2150-766X
ISSN On-line: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v5.i1-6.430
pages 397-406

EVOLUTION OF ALUMINUM AGGLOMERATES MOVING IN COMBUSTION PRODUCTS OF MODEL SOLID PROPELLANT

Oleg G. Glotov
Institute of Chemical Kinetics and Combustion, Russia
V. V. Karasev
Institute of Chemical Kinetics and Combustion, Russia
Vladimir Zarko
ICKC SB RAS
T. D. Fedotova
Novosibirsk State University, Russia
Merrill W. Beckstead
Brigham Young University, Provo Utah USA

RESUMO

Based on the use of special propellants that generate model monodisperse agglomerates with given size and structure during combustion, a new approach has been elaborated for reducing the uncertainty in data obtained on agglomerate evolution. The experiments with agglomerates of 400−540 μm in size and initial aluminum content 42.6 % were carried out under pressures 10−64 atm. Via direct size and weight measurements and chemical analyses of sampled particles, the following correlation for incompleteness of aluminum combustion (η) has been found: η = 2.86t−0.28P−0.20, where η = mAl/mAl0; mAl is the mass of free aluminum in sampled agglomerate and mAl0 is the initial mass of aluminum in agglomerate; t is the residence time for agglomerate in flame of burning sample (20<t<90 ms); P is the pressure (10<P<64 atm). The mass fraction (φ) of oxide accumulated on the burning agglomerate was found to increase with extent of aluminum conversion ξ = 1−η as ξ = 0.539 + 0.213ξ. The agglomerate mass also increases with ξ due to oxide accumulation on the burning agglomerate. For calculation of 1) the burning agglomerate motion law and 2) the residence time for agglomerate in the flame, the drag coefficient Cd was assumed in the form Cd = K/Re, where Re is the Reynolds number. K was determined in special experiments on panicle trajectory visualization at pressure 1 atm and found to be equal to K = 45±7 for 7<Re<9.


Articles with similar content:

EFFECT OF AN ACOUSTIC FIELD ON HYDRODYNAMICS OF A BINARY MIXTURE OF POWDERS
Multiphase Science and Technology, Vol.27, 2015, issue 2-4
R. L. Sonolikar, Akash Langde, D. J. Tidke
MASS AND HEAT TRANSFERS BY FORCED CONVECTION DURING LIQUID FILM EVAPORATION IN A CHANNEL WITH A BUILT-IN POROUS SQUARE CYLINDER
Journal of Porous Media, Vol.22, 2019, issue 4
Ali Hatem Laatar, Xavier Chesneau, Hamza Mahdhaoui
IGNITION AND COMBUSTION OF Mg-COATED AND UNCOATED BORON PARTICLES
International Journal of Energetic Materials and Chemical Propulsion, Vol.3, 1994, issue 1-6
W. Felder, W. H. Hsieh, Chun-Liang Yeh
MODELING INTERPHASE TURBULENT KINETIC ENERGY TRANSFER IN LAGRANGIAN-EULERIAN SPRAY COMPUTATIONS
Atomization and Sprays, Vol.16, 2006, issue 7
Shankar Subramaniam, M. G. Pai
ENHANCEMENT OF THERMAL EFFICIENCY BY USING HEMISPHERICAL PROTRUSIONS ON SOLAR AIR HEATERS
International Journal of Energy for a Clean Environment, Vol.15, 2014, issue 1
Ravi Kumar Sangewar