ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Heat Transfer Research
インパクトファクター: 1.199 5年インパクトファクター: 1.155 SJR: 0.267 SNIP: 0.503 CiteScore™: 1.4

ISSN 印刷: 1064-2285
ISSN オンライン: 2162-6561

巻:
巻 51, 2020 巻 50, 2019 巻 49, 2018 巻 48, 2017 巻 47, 2016 巻 46, 2015 巻 45, 2014 巻 44, 2013 巻 43, 2012 巻 42, 2011 巻 41, 2010 巻 40, 2009 巻 39, 2008 巻 38, 2007 巻 37, 2006 巻 36, 2005 巻 35, 2004 巻 34, 2003 巻 33, 2002 巻 32, 2001 巻 31, 2000 巻 30, 1999 巻 29, 1998 巻 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.2018026835
pages 1023-1041

EXPERIMENTAL INVESTIGATIONS OF FLAME PATTERNS OBSERVED FOR LPG/AIR PREMIXTURE USED IN SMALL-SCALE SWISS ROLL COMBUSTOR

Sagar B. Mane Deshmukh
Department of Mechanical Engineering, Sathyabama Institute of Science and Technology, Chennai 600119, Tamilnadu, India
A. Krishnamoorthy
Department of Mechanical Engineering, Sathyabama Institute of Science and Technology, Chennai 600119, Tamilnadu, India
Virendra K. Bhojwani
Department of Mechanical Engineering, Jayawantrao Sawant College of Engineering, Savitribai Phule Pune University, Pune 411028, Maharashtra, India

要約

The present paper discusses testing of a small-scale Swiss roll combustor with two rectangular adjacent channels. Swiss roll combustors were tested using a liquefied petroleum gas (LPG) and an air pre-mixture. The following parameters, viz., the mixture equivalence ratio, mixture flow rate, and Swiss roll combustor channel depth were varied and their effect on the occurrence of different flame patterns formed in the combustor is monitored and reported. The flow rate of LPG was varied in the range from 0.25 LPM to 0.55 LPM. Nine different types of flame patterns were observed in the combustor, viz. planar, concave (or U-shaped), conical with short height and large base, conical with larger height and small base, elliptical, triangular, circular, triangular with tail, and elliptical with tail. Triangular flame with tail achieved highest combustion space temperatures as compared to other flame types listed above. The triangular flame with tail was generally observed for maximum number of Swiss roll combustor models tested (SW10, SW15, and SW20) at a wide variety of flow rates in comparison with other eight flame types. The lowest combustion space temperature was observed for planar flame type for which flame stability was also achieved for a narrow range of flow rates. Swiss roll combustors with higher channel depths showed higher maximum temperatures compared to the lower depth combustors. A flame with different pattern/shapes is observed in different regions in the combustion space of the combustor. A planar flame was noticed below 5-mm depth combustor. The tests indicated that the flame characteristics/patterns are strongly dependent on the mixture equivalence ratio, mixture flow rates, combustor depth, and heat recirculation from products to reactants.

参考

  1. Ahn, J., Eastwood, C., Sitzki, L., and Rooney, P.D., Gas-Phase and Catalytic Combustion in Heat-Recirculating Burners, Proc. Combust. Inst., vol. 30, pp. 2463-2472, 2005.

  2. Akram, M. and Kumar, S., Experimental Studies on Dynamics of Methane-Air Premixed Flame in Meso-Scale Diverging Channels, Combust. Flame, vol. 158, pp. 915-924, 2011.

  3. Bei-Jing, Z. and Jian-Hua, W., Experimental Study on Premixed CH4/Air Mixture Combustion in Micro Swiss Roll Combustor, Combust. Flame, vol. 157, pp. 2222-2229, 2010.

  4. Chen, C.H., Gowdagiri, S., Kumar, S., and Ronney, P.D., Numerical and Experimental Study in Swiss Roll Heat-Recirculating Burner, PowerMEMS 2009, Washington, DC, USA, December 1-4, 2009.

  5. Chen, C.H. and Ronney, P.D., Three-Dimensional Effects in Counter Flow Heat-Rercirculating Combustors, Proc. Combust. Inst., vol. 33, pp. 3285-3291, 2011.

  6. Chen, C.H., Sur, S., Thayer, J., Pearlman, H., and Ronney, P., A Non Catalytic Fuel Flexible Reformer, 8th U.S. National Combustion Meeting Organized by the Western States Section of the Combustion Institute and Hosted by the University of Utah, May 19-22, 2013.

  7. Fan, A., Maruta, K., Nakamura, H., Kumar, S., and Liu, W., Experimental Investigation on Flame Pattern Formations of the DME-Air Mixtures in a Radial Micro Channel, Combust. Flame, vol. 157, pp. 1637-1642, 2010.

  8. Fernandez-Pello, A.C., Micro Power Generation using Combustion: Issues and Approaches, Proc. Combust. Inst., vol. 29, no.1, pp. 883-899, 2002.

  9. Fujiwara, K. and Nakamura, Y., Experimental Study on the Stability Mechanism via Miniaturization of Jet Diffusion Flames (Micro Flame) by Utilizing Preheated Air System, Combust. Flame, vol. 160, pp. 1373-1380, 2013.

  10. Ibrahim, S.S., Hargrave, G.K., and Williams, T.C., Experimental Investigations of Flame/Solid Interactions in Turbulent Premixed Combustion, Exp. Therm. Fluid Sci., vol. 24, pp. 99-106, 2011.

  11. Jejurkar, S.Y. and Mishra, D.P., A Review of Recent Patents on Micro-Combustion and Applications, Recent Patents on Engineering, vol. 3, pp. 194-209, 2009.

  12. Jomde, A., Anderson, A., Bhojwani, V., and Deshmukh, M., Performance Predictions and Parametric Analysis of a Valved Linear Compressor Using a Mathematical Model, J. Ambient Energy, 2017. DOI: 10.1080/01430750.2017.1318784.

  13. Jomde, A., Anderson, A., Bhojwani, V., Khedia, S., Jangale, N., Kolas, K., and Khedkar, P., Modeling and Measurement of a Moving Coil Oil Free Linear Compressor Performance for Refrigeration Application Using R134a, Int. J. Refrig., vol. 88, pp. 182-194, 2018.

  14. Ju, Y. and Choi, C.W., An Analysis of Sub-Limit Flame Dynamics Using Opposite Propagating Flames in Meso Scale Channels, Combust. Flame, vol. 133, pp. 483-493, 2003.

  15. Ju, Y. and Maruta, K., Micro Scale Combustion: Technology Development and Fundamental Research, Prog. Energy Combust. Sci., vol. 37, no. 6, pp. 669-715, 2011.

  16. Kim, N.I., Kataoka, S.T., Yokomori, T.S., Fujimori T., and Maruta, K., Flame Stabilization and Emission of Small Swiss Roll Combustor as Heaters, Combust. Flame, vol. 141, pp. 229-240, 2005.

  17. Katsuyoshi, T., Soichiro, K., and Toshiyuki, M.S., Development of the Micro Combustor, IHI Eng. Rev., vol. 42, pp. 97-102, 2009.

  18. Khandelwal, B., Sahota, G.P.S., and Kumar, S., Investigations into the Flame Stability Limits in a Backward Step Micro Scale Combustor with Premixed Methane-Air Mixtures, J. Micromech. Microeng., vol. 20, p. 095030, 2010.

  19. Kim, N.I., Maruta, K., Aizumi, S., Yokomori, T., and Hasegawa, S., Development of Small Scale Swiss Roll Combustor and Its Scale Effect, The Fifth Int. Workshop on Micro and Nanotechnology for Power Generation and Energy Conversion Applications, PowerMEMS2005, Takeda Hall, The University of Tokyo, Japan, November 28-30, 2005.

  20. Kumar, S., Maruta, K., and Minaev, S., Experimental Investigations on the Combustion Behavior of Methane-Air Mixtures in a Micro Scale Radial Combustion Configuration, J. Micromech. Microeng., vol. 17, no. 5, pp. 900-908, 2007.

  21. Lee, I.C., Small Scale Burner Review, Army Research Laboratory, Adelphi, MD, Tech. Rep. ARL-TR-4881, 2009.

  22. Lee, M.J., Cho, S.M., Choi, B.I., and Kim, N.I., Scale and Materials Effects on Flame Characteristics in Small Heat Recirculation Combustors of Counter-Current Channel Type, Appl. Therm. Eng., vol. 30, pp. 222-2235, 2010.

  23. Lloyd, S.A. and Weinberg, F.J., A Burner for Mixtures of Very Low Heat Content, Nature, vol. 251, pp. 47-49, 1974.

  24. Lloyd, S.A. and Weinberg, F.J., Limit to Energy Release and Utilization from Chemical Fuels, Nature, vol. 252, pp. 367-370, 1975.

  25. Mane-Deshmukh, S.B., Bhojwani, V.K., Krishnamoorthy, A., Avati, V., Patil, S., and Mandale, E., Experimental Investigations of the Characteristics of the Heat Recovering/Recuperating One Turn Exhaust Channel Stainless Steel and Aluminum Combustors, Proc. of Sixth National Conf. on Recent Advances in Manufacturing, RAM-2016, SVNIT, Surat, India, May 12-14, 2016.

  26. Mane-Deshmukh, S.B., Krishnamoorthy, A., and Bhojwani, V.K., Experimental Research on The Effect of Materials of One Turn Swiss Roll Combustor on Its Thermal Performance as a Heat Generating Device, Mater. Today: Proc., vol. 5, pp. 737-744, 2018a.

  27. Mane-Deshmukh, S.B., Krishnamoorthy, A., and Bhojwani, V.K., Experimental Investigations of Effect of Depth of Swiss Roll Combustor on Its Thermal Performance as a Heat Generator, Int. J. Ambient Energy, 2018b. DOI: 10.1080/01430750.2017.1423377.

  28. Mane-Deshmukh, S.B., Krishnamoorthy, A., Bhojwani, V.K., and Pawane, A., Experimental Investigations on Effect of Different Materials and Varying Depths of One Turn Exhaust Channel Swiss Roll Combustor on Its Thermal Performance, IOP Conf. Series: Mater. Sci. Eng., vol. 197, p. 012031, 2017. DOI: 10.1088/1757-899X/197/1/012031.

  29. Ronney, P.D., Analysis of Non-Adiabatic Heat-Recirculating Combustors, Combust. Flame, vol. 135, pp. 421-439, 2003.

  30. Sitzki, L., Borer, K., Schuster, E., and Ronney, P.D., Combustion in Micro Scale Heat Recirculating Burners, The Third Asia Pacifi c Conf. on Combustion, Seoul, Korea, June 24-27, 2001.

  31. Takase, K., Li, X., Nakamura, H., Tezuka, T., Hasegawa, S., Katsuta, M., Kikuchi, M., and Maruta, K., Extinction Characteristics of CH4/O2/Xe Radiative Counter Flow Planner Premixed Flames and Their Transition to Ball-Like Flames, Combust. Flame, vol. 160, pp. 1235-1241, 2013.

  32. Vijayan, V. and Gupta, A.K., Combustion and Heat Transfer at Meso Scale with Thermal Energy Recirculation, 47th AIAA, Orlando, Florida, January 5-8, 2009.

  33. Walther, D.C. and Ahn, J., Advances and Challenges in the Development of Power Generation Systems at Small Scale, Prog. Energy Sci. Combust., vol. 37 pp. 583-610, 2011.


Articles with similar content:

STUDY COMBUSTION MODEL OF PETROLEUM COKES BY TGA
Proceedings of Symposium on Energy Engineering in the 21st Century (SEE2000) Volume I-IV, Vol.0, 2000, issue
Bo-Xiong Shen, Han-Ping Chen, De-Chang Liu
HIGH-SPEED LIF-OH IMAGING OF H2–AIR TURBULENT PREMIXED FLAMES PROPAGATION IN AN OBSTRUCTED CHAMBER
Heat Transfer Research, Vol.49, 2018, issue 7
Ahmed A. Alharbi
HEAT TRANSFER IN DUCTS ROTATING AROUND A PERPENDICULAR AXIS
International Heat Transfer Conference 6, Vol.2, 1978, issue
D. Skiadaressis , Dudley Brian Spalding
INVESTIGATION OF ROTATIONAL SYMMETRY IN VORTEX-DRIVEN ACOUSTIC OSCILLATIONS IN A LABORATORY-SCALE SWIRL COMBUSTOR
Journal of Flow Visualization and Image Processing, Vol.26, 2019, issue 1
Satyanarayanan R. Chakravarthy, Vikram Ramanan
EFFECT OF FLASH-TUBE VENT-HOLE PATTERNS ON THE COMBUSTION PRODUCT DISCHARGE RATE
International Journal of Energetic Materials and Chemical Propulsion, Vol.8, 2009, issue 3
Jeffrey D. Moore, Ragini Acharya, Peter J. Ferrara