ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Heat Transfer Research
インパクトファクター: 0.404 5年インパクトファクター: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN 印刷: 1064-2285
ISSN オンライン: 2162-6561

巻:
巻 51, 2020 巻 50, 2019 巻 49, 2018 巻 48, 2017 巻 47, 2016 巻 46, 2015 巻 45, 2014 巻 44, 2013 巻 43, 2012 巻 42, 2011 巻 41, 2010 巻 40, 2009 巻 39, 2008 巻 38, 2007 巻 37, 2006 巻 36, 2005 巻 35, 2004 巻 34, 2003 巻 33, 2002 巻 32, 2001 巻 31, 2000 巻 30, 1999 巻 29, 1998 巻 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.2019028790
pages 1737-1747

EXPERIMENTAL STUDY OF COHERENT FLOW STRUCTURES BEHIND TWO SIMILAR NORMAL FLAT PLATES IN TANDEM ARRANGEMENT

Arian Bahrami
Aerodynamics Laboratory, Department of Mechanical Engineering, Eastern Mediterranean University, Northern Cyprus, Via Mersin 10, Turkey
Hasan Hacisevki
Aerodynamics Laboratory, Department of Mechanical Engineering, Eastern Mediterranean University, Northern Cyprus, Via Mersin 10, Turkey

要約

Flow structures behind two identical normal flat plates in tandem arrangement have been investigated for various gap ratios (g/D) between the plates at a high Reynolds number of 3.3 × 104. Constant-temperature hot wire anemometers (CTA) were employed to quantitatively measure the near wake properties behind the downstream plate. The effects of various gap ratios (g/D) ranging from 0.2 to 2.0 were probed, and it was observed that the wake region behind the normal flat plates in tandem arrangement exhibits higher Strouhal number than a normal single flat plate. Moreover, the plotted contours demonstrated that the centerline behind the plates encountered a shedding frequency corresponding to twice the reference shedding frequency (2fs). Finally, regions associated with the highest Reynolds stress were spotted along the edges of the plates in the wake region.

参考

  1. Afgan, I., Benhamadouche, S., Han, X., Sagaut, P., and Laurence, D., Flow over a Flat Plate with Uniform Inlet and Incident Coherent Gusts, J. FluidMech., vol. 720, pp. 457-485, 2013.

  2. Auteri, F., Belan, M., Cassinelli, C., and Gibertini, G., Interacting Wakes of Two Normal Flat Plates: An Investigation Based on Phase Averaging of LDA Signals, J. Visualiz., vol. 12, pp. 307-321, 2009.

  3. Auteri, F., Belan, M., Gibertini, G., and Grassi, D., Normal Flat Plates in Tandem: An Experimental Investigation, J. Wind Eng. Ind. Aerod., vol. 96, pp. 872-879, 2008.

  4. Bentley, J. and Mudd, J., Vortex Shedding Mechanisms in Single and Dual Bluff Bodies, Flow Meas. Instrum., vol. 14, pp. 23-31, 2003.

  5. Chein, R. and Chung, J., Discrete-Vortex Simulation of Flow over Inclined and Normal Plates, Comput. Fluids, vol. 16, pp. 405-427, 1988.

  6. Hacisevki, H. and Teimourian, A., Comparison of Flow Structures in the Wake Region of Two Similar Normal Flat Plates in Tandem and a Square Cylinder, Exp. Therm. Fluid Sci., vol. 69, pp. 169-177, 2015.

  7. Hacisevki, H. and Teimourian, A., Interacting Wakes of a Narrow and a Wide Flat Plate in Tandem Arrangement, Fluid Dyn. Res., vol. 48, 015505, 2016.

  8. Hangan, H. and Vickery, B., Buffeting of Two-Dimensional Bluff Bodies, J. Wind Eng. Ind. Aerod., vol. 82, pp. 173-187, 1999.

  9. Hussain, A., Coherent Structures and Turbulence, J. FluidMech., vol. 173, pp. 303-356, 1986.

  10. Irwin, P.A., Bluff Body Aerodynamics in Wind Engineering, J. Wind Eng. Ind. Aerod., vol. 96, pp. 701-712, 2008.

  11. Kiya, M. and Matsumura, M., Incoherent Turbulence Structure in the Near Wake of a Normal Plate, J. Fluid Mech., vol. 190, pp. 343-356, 1988.

  12. Matsumoto, M., Vortex Shedding of Bluff Bodies: A Review, J. Fluids Struct., vol. 13, pp. 791-811, 1999.

  13. Mazharoglu, C. and Hacisevki, H., Coherent and Incoherent Flow Structures Behind a Normal Flat Plate, Exp. Therm. Fluid Sci., vol. 19, pp. 160-167, 1999.

  14. Nakamura, Y., Vortex Shedding from Bluff Bodies and a Universal Strouhal Number, J. Fluids Struct., vol. 10, pp. 159-171, 1996.

  15. Narasimhamurthy, V.D. and Andersson, H.I., Numerical Simulation of the Turbulent Wake Behind a Normal Flat Plate, Int. J. Heat Fluid Flow, vol. 30, pp. 1037-1043, 2009.

  16. Reynolds, W. and Hussain, A., The Mechanics of an Organized Wave in Turbulent Shear Flow. Part 3. Theoretical Models and Comparisons with Experiments, J. Fluid Mech., vol. 54, pp. 263-288, 1972.

  17. Saha, A.K., Far-Wake Characteristics of Two-Dimensional Flow Past a Normal Flat Plate, Phys. Fluids, vol. 19, 128110, 2007.

  18. Sumner, D., Two Circular Cylinders in Cross-Flow: A Review, J. Fluids Struct., vol. 26, pp. 849-899, 2010.

  19. Teimourian, A., Hacisevki, H., and Bahrami, A., Experimental Study on Flow Past Two Inclined Flat Plates in Tandem Arrangement, J. Wind Eng. Ind. Aerod., vol. 169, pp. 1-11, 2017.

  20. Zdravkovich, M.M., Different Modes of Vortex Shedding: An Overview, J. Fluids Struct., vol. 10, pp. 427-437, 1996.

  21. Zdravkovich, M.M., Flow around Circular Cylinders: Vol. 1. Fundamentals, J. Fluid Mech., vol. 350, pp. 377-378, 1997.

  22. Zdravkovich, M.M., Flow Around Circular Cylinders: Vol. 2. Applications, Oxford, UK: Oxford University Press, 2003.

  23. Zhang, H. and Melbourne, W., Interference between Two Circular Cylinders in Tandem in Turbulent Flow, J. Wind Eng. Ind. Aerod., vol. 41, pp. 589-600, 1992.