Library Subscription: Guest
Begell Digital Portal Begell Digital Library eBooks Journals References & Proceedings Research Collections
Heat Transfer Research
IF: 0.404 5-Year IF: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN Print: 1064-2285
ISSN Online: 2162-6561

Volumes:
Volume 51, 2020 Volume 50, 2019 Volume 49, 2018 Volume 48, 2017 Volume 47, 2016 Volume 46, 2015 Volume 45, 2014 Volume 44, 2013 Volume 43, 2012 Volume 42, 2011 Volume 41, 2010 Volume 40, 2009 Volume 39, 2008 Volume 38, 2007 Volume 37, 2006 Volume 36, 2005 Volume 35, 2004 Volume 34, 2003 Volume 33, 2002 Volume 32, 2001 Volume 31, 2000 Volume 30, 1999 Volume 29, 1998 Volume 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.v35.i78.20
14 pages

Characteristic Features of Hydrodynamics and Heat Transfer in Transverse Flow Past Cylinders with Dimples in Single-Row Bundles

G. V. Kovalenko
Institute of Technical Thermophysics, National Academy of Sciences of Ukraine, Kiev
Artem Khalatov
Institute of Engineering Thermophysics, National Academy of Sciences of Ukraine 2A Zhelyabov St., Kiev-57, 03057, Ukraine

ABSTRACT

The results of experimental investigation of heat transfer and characteristic features of the hydrodynamics in transverse air flow past single-row bundles of cylinders, the surface of which is made up of the systems of symmetric and asymmetric cylindrical dimples are presented. In the investigated range of Reynolds numbers from 3300 to 63,000, the maximum degree of heat transfer intensification in comparison with a smooth cylinder attains 1.78, whereas the hydraulic resistance of the bundle is increased by a value less than 14%. Some kinds of the investigated systems of dimples favor a decrease in the zone of reverse flows downstream of a cylinder by a factor of 2−4. The frequencies of sonic vibrations generated during flow past the dimples located near the front point of the cylinder are close to the frequencies appearing in flow past the same dimples located on a plane surface. The possibility of purposeful selection of the diameter of dimples for maximum reduction in the length of the zone of reverse flows behind cylinder is shown.