Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
International Journal for Multiscale Computational Engineering
Facteur d'impact: 1.016 Facteur d'impact sur 5 ans: 1.194 SJR: 0.554 SNIP: 0.68 CiteScore™: 1.18

ISSN Imprimer: 1543-1649
ISSN En ligne: 1940-4352

International Journal for Multiscale Computational Engineering

DOI: 10.1615/IntJMultCompEng.2018026027
pages 367-376

MODELING PLASTIC DEFORMATION OF NANO/SUBMICRON-SIZED TUNGSTEN PILLARS UNDER COMPRESSION: A COARSE-GRAINED ATOMISTIC APPROACH

Shuozhi Xu
California NanoSystems Institute, University of California, Santa Barbara, California 93106-6105, USA

RÉSUMÉ

In this work, coarse-grained atomistic simulations via the concurrent atomistic-continuum (CAC) method are performed to investigate compressive deformation of nano-/submicron-sized pillars in body-centered cubic (BCC) tungsten. Two models with different surface roughness are considered. All pillars have the same height-to-diameter aspect ratio of 3, with the diameter ranging from 27.35 to 165.34 nm; as a result, the largest simulation cell contains 291,488 finite elements, compared to otherwise ≈ 687.82 million atoms in an equivalent full atomistic model. Results show that (i) a larger surface roughness leads to a lower yield stress and (ii) the yield stress of pillars with a large surface roughness scales nearly linearly with the diameter while that of pillars with smooth surfaces scales exponentially with the diameter, the latter of which agrees with experiments. The differences in the yield stress between the two models are attributed to their different plastic deformation mechanisms: in the case of large surface roughness, dislocation nucleation is largely localized near the ends of the pillars; and in pillars with smooth surfaces, dislocation avalanches in a more homogeneous manner are observed. This work, which is the first attempt to simulate BCC systems using the CAC method, highlights the significance of the surface roughness in uniaxial deformation of nano-/submicropillars.


Articles with similar content:

Multiscale Modeling of Point and Line Defects in Cubic Lattices
International Journal for Multiscale Computational Engineering, Vol.5, 2007, issue 3-4
John Clayton, Peter W. Chung
Atomistically Informed Mesoscale Model of Alpha-Helical Protein Domains
International Journal for Multiscale Computational Engineering, Vol.7, 2009, issue 3
Zhao Qin, Markus J. Buehler, Jeremie Bertaud
Calibration of Nanocrystal Grain Boundary Model Based on Polycrystal Plasticity Using Molecular Dynamics Simulations
International Journal for Multiscale Computational Engineering, Vol.8, 2010, issue 5
Sangmin Lee, Veera Sundararaghavan
THE ENERGY SPECTRUM ANALOGY BREAKUP (SAB) MODEL FOR THE NUMERICAL SIMULATION OF SPRAYS
Atomization and Sprays, Vol.21, 2011, issue 12
Chawki Habchi
PHASE CHANGE IN AN ADSORBED VAPOR LEADING TO THE WETTING TRANSITIONS
International Heat Transfer Conference 16, Vol.16, 2018, issue
Yourong Li, Xiang Wei, Chunmei Wu, Lin Ding