High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
Publication de 4 numéros par an
ISSN Imprimer: 1093-3611
ISSN En ligne: 1940-4360
IF:
0.4
Immediacy Index:
0.1
Eigenfactor:
0.00005
JCI:
0.07
SJR:
0.198
SNIP:
0.48
CiteScore™::
1.1
H-Index:
20
Indexed in
Characterization of a vortex-stabilized arc plasma torch using simple power expressions
Volume 1,
Numéro 1, 1997,
pp. 49-53
DOI: 10.1615/HighTempMatProc.v1.i1.40
RÉSUMÉ
A complete characterization of an air vortex-stabilized plasma torch was carried out with the application of simple power relationships. Voltage and efficiency were generalized by the correspondent characteristic equations as functions of current and gas flow rate. The power expressions approximations showed good agreement with the experimental results. We also calculated the mass average plasma enthalpy and the temperature at the exit of the torch. Simple equations, independent on the flow rate, were obtained for the calculations of the thermal losses as function of the current and of the efficiency as function of the arc voltage.
399 Vues d'articles
15 Téléchargements d'articles
Métrique
Articles avec un contenu similaire:
Dernier numéro
DETERMINATION OF THE MASS BALANCE OF HIGH-CARBON FERROCHROME IN A SUBMERGED ARC FURNACE
RHEOLOGICAL BEHAVIOR AND 3D PRINTING OF HIGHLY FILLED ALUMINA-POLYAMIDE FILAMENTS DURING FUSED DEPOSITION MODELING
SCRATCH TESTING OF ZrN COATING ON TI-6AL-4V TITANIUM ALLOY SURFACE PRELIMINARY TREATED BY COMPRESSION PLASMA FLOWS IMPACT
ELECTRON-BEAM SINTERING OF ZIRCONIUM DIOXIDE/TITANIUM CERAMICS FOR MICROELECTRONICS PRODUCTS
THE EFFECT OF THE FLUORINE CONCENTRATION IN A PLASMA-FORMING GAS MIXTURE ON THE CHEMICAL COMPOSITION, SURFACE CHARGE, AND RELIEF PARAMETERS OF FLUOROCARBON COATINGS ON PET
PREPARATION AND THERMOELECTRIC PROPERTIES OF p-TYPE Ag(1-x)Cu(1+x)Te SAMPLES BY SPARK PLASMA SINTERING METHOD
Prochains articles
PLASMA DISCHARGE IN LIQUID MEDIA UNDER THE EFFECT OF ULTRASOUND FOR THE SYNTHESIS OF FILLERS FOR POLYMER COMPOSITES WITH ENHANCED MECHANICAL STRENGTH AND GAS PERMEABILITY
THE QUALITY OF THIN-WALLED STRUCTURES OF AlSi10Mg PRODUCED BY SELECTIVE LASER MELTING
PHYSICAL AND MECHANICAL PROPERTIES AND OPERATIONAL CHARACTERISTICS OF CORONA SPRAYED POWDER COATINGS
Increasing the wear resistance of titanium alloys by deposition of a modifying coating (Zr,Nb)N
Electron-beam synthesis of zirconia ceramic coatings in the forevacuum pressure range
Preparation and Thermoelectric Properties of P-type Ag(1-x)Cu(1+x)Te Samples by SPS Method
The effect of the fluorine concentration in a plasma-forming gas mixture on the chemical composition, surface charge and relief parameters of fluorocarbon coatings on PET
Electron beam sintering of zirconium dioxide/titanium ceramics for microelectronics products