High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
Publication de 4 numéros par an
ISSN Imprimer: 1093-3611
ISSN En ligne: 1940-4360
IF:
0.4
Immediacy Index:
0.1
Eigenfactor:
0.00005
JCI:
0.07
SJR:
0.198
SNIP:
0.48
CiteScore™::
1.1
H-Index:
20
Indexed in
ON-LINE DIAGNOSTIC OF THE GASEOUS EFFLUENT OF A FLY ASH TREATMENT PLASMA PROCESS: SET-UP OF A CHEMICAL BALANCE
Volume 5,
Numéro 2, 2001,
9 pages
DOI: 10.1615/HighTempMatProc.v5.i2.20
RÉSUMÉ
Plasma processes are today considered as one of the most promising techniques for the treatment of industrial or domestic waste incineration for they are fast and cheap in terms of energy consumption. The most important part of this paper relies on the development of a clean-up and GC/MS analysis protocol for fly ash volatile organic compounds identification, and on the monitoring of metallic oxides and chlorides evaporation during the plasma treatment by optical emission spectroscopy. Thermal and chemical balances were evaluated in order to optimize the process, also in regards to environmental regulation constraints.
749 Vues d'articles
7 Téléchargements d'articles
Métrique
Articles avec un contenu similaire:
Dernier numéro
DETERMINATION OF THE MASS BALANCE OF HIGH-CARBON FERROCHROME IN A SUBMERGED ARC FURNACE
RHEOLOGICAL BEHAVIOR AND 3D PRINTING OF HIGHLY FILLED ALUMINA-POLYAMIDE FILAMENTS DURING FUSED DEPOSITION MODELING
SCRATCH TESTING OF ZrN COATING ON TI-6AL-4V TITANIUM ALLOY SURFACE PRELIMINARY TREATED BY COMPRESSION PLASMA FLOWS IMPACT
ELECTRON-BEAM SINTERING OF ZIRCONIUM DIOXIDE/TITANIUM CERAMICS FOR MICROELECTRONICS PRODUCTS
THE EFFECT OF THE FLUORINE CONCENTRATION IN A PLASMA-FORMING GAS MIXTURE ON THE CHEMICAL COMPOSITION, SURFACE CHARGE, AND RELIEF PARAMETERS OF FLUOROCARBON COATINGS ON PET
PREPARATION AND THERMOELECTRIC PROPERTIES OF p-TYPE Ag(1-x)Cu(1+x)Te SAMPLES BY SPARK PLASMA SINTERING METHOD
Prochains articles
PLASMA DISCHARGE IN LIQUID MEDIA UNDER THE EFFECT OF ULTRASOUND FOR THE SYNTHESIS OF FILLERS FOR POLYMER COMPOSITES WITH ENHANCED MECHANICAL STRENGTH AND GAS PERMEABILITY
THE QUALITY OF THIN-WALLED STRUCTURES OF AlSi10Mg PRODUCED BY SELECTIVE LASER MELTING
PHYSICAL AND MECHANICAL PROPERTIES AND OPERATIONAL CHARACTERISTICS OF CORONA SPRAYED POWDER COATINGS
Increasing the wear resistance of titanium alloys by deposition of a modifying coating (Zr,Nb)N
Electron-beam synthesis of zirconia ceramic coatings in the forevacuum pressure range
Preparation and Thermoelectric Properties of P-type Ag(1-x)Cu(1+x)Te Samples by SPS Method
The effect of the fluorine concentration in a plasma-forming gas mixture on the chemical composition, surface charge and relief parameters of fluorocarbon coatings on PET
Electron beam sintering of zirconium dioxide/titanium ceramics for microelectronics products