Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.142 SNIP: 0.16 CiteScore™: 0.29

ISSN Imprimer: 2150-766X
ISSN En ligne: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v5.i1-6.430
pages 397-406

EVOLUTION OF ALUMINUM AGGLOMERATES MOVING IN COMBUSTION PRODUCTS OF MODEL SOLID PROPELLANT

Oleg G. Glotov
Institute of Chemical Kinetics and Combustion, Russia
V. V. Karasev
Institute of Chemical Kinetics and Combustion, Russia
Vladimir Zarko
ICKC SB RAS
T. D. Fedotova
Novosibirsk State University, Russia
Merrill W. Beckstead
Brigham Young University, Provo Utah USA

RÉSUMÉ

Based on the use of special propellants that generate model monodisperse agglomerates with given size and structure during combustion, a new approach has been elaborated for reducing the uncertainty in data obtained on agglomerate evolution. The experiments with agglomerates of 400−540 μm in size and initial aluminum content 42.6 % were carried out under pressures 10−64 atm. Via direct size and weight measurements and chemical analyses of sampled particles, the following correlation for incompleteness of aluminum combustion (η) has been found: η = 2.86t−0.28P−0.20, where η = mAl/mAl0; mAl is the mass of free aluminum in sampled agglomerate and mAl0 is the initial mass of aluminum in agglomerate; t is the residence time for agglomerate in flame of burning sample (20<t<90 ms); P is the pressure (10<P<64 atm). The mass fraction (φ) of oxide accumulated on the burning agglomerate was found to increase with extent of aluminum conversion ξ = 1−η as ξ = 0.539 + 0.213ξ. The agglomerate mass also increases with ξ due to oxide accumulation on the burning agglomerate. For calculation of 1) the burning agglomerate motion law and 2) the residence time for agglomerate in the flame, the drag coefficient Cd was assumed in the form Cd = K/Re, where Re is the Reynolds number. K was determined in special experiments on panicle trajectory visualization at pressure 1 atm and found to be equal to K = 45±7 for 7<Re<9.


Articles with similar content:

BURNING RATE CHARACTERIZATION OF OXSOL LIQUID OXIDIZER
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
J. W. Mordosky, George C. Harting, T. T. Cook, Baoqi Zhang
THE FULLY LAGRANGIAN APPROACH TO THE ANALYSIS OF PARTICLE/DROPLET DYNAMICS: IMPLEMENTATION INTO ANSYS FLUENT AND APPLICATION TO GASOLINE SPRAYS
Atomization and Sprays, Vol.27, 2017, issue 6
Morgan R. Heikal, Steven M. Begg, Oyuna Rybdylova, Artur K. Gilfanov, Timur S. Zaripov, Sergei S. Sazhin
An Experimental Study on Droplet Interactions
International Journal of Fluid Mechanics Research, Vol.24, 1997, issue 4-6
J. F. Virepinte, G. Lavergne, Y. Biscos, O. Adam
TEMPERATURE SENSITIVITY MEASUREMENTS AND REGRESSION BEHAVIOR OF A FAMILY OF BORON-BASED VERY HIGH BURNING RATE PROPELLANTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.2, 1993, issue 1-6
W. H. Hsieh, R. M. Salizzoni
EXPERIMENTAL INVESTIGATION OF THE PHENOMENON OF OIL BREAKUP IN AN ENGINE CRANKCASE
Atomization and Sprays, Vol.20, 2010, issue 9
Morgan R. Heikal, Steven M. Begg, G. de Sercey, Y. Mamiya, Nicolas Miche, R. Gilchrist, Y. Noda, Y. Tsuruoka