Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN Imprimer: 2150-766X
ISSN En ligne: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v5.i1-6.470
pages 438-452

COMBUSTION AND FLAME SPREADING OF ALUMINUM TUBING IN HIGH PRESSURE OXYGEN

M. M. Mench
Department of Mechanical Engineering, The Pennsylvania State University, University Park, PA 16802, U.S.A.
J. P. Haas
Honeywell, NASA White Sands Test Facility, Las Craces, NM 88004, USA

RÉSUMÉ

The promoted ignition, flame spreading, and combustion phenomena of aluminum alloy 3003 tubing in high-pressure gaseous oxygen (GOX) were studied. The motivation for this study is to obtain burn rate data for aluminum 3003 in a high-pressure GOX environment and to compare the results with the burning behavior of aluminum in liquid oxygen (LOX) at lower pressure. The violent burning of aluminum in a LOX environment has been termed a violent energy release, or VER reaction. This reaction has been observed to result in extremely rapid combustion of aluminum at rates many times greater than that of aluminum in a GOX environment at similar pressures. The upward burning rate data for aluminum tubing in high-pressure quiescent oxygen indicate that no VER reaction exists in this environment, despite the high ambient GOX density. The burning rates of aluminum tubes with two different wall thicknesses are correlated using a power-law relationship for pressures ranging from 2.76 to 55.16 MPa, yielding a pressure exponent of around 0.6 for both cases. High-speed video of the burning event was also recorded, showing the periodic dripping of molten satellite particles. The molten droplet growth and drop-off cycle becomes more rapid with increasing pressure. An equation describing the growth of molten material accumulation is derived to explain this behavior.


Articles with similar content:

THERMAL ANALYSIS OF IRON RODS BURNING IN NORMAL-GRAVITY AND REDUCED-GRAVITY
International Heat Transfer Conference 13, Vol.0, 2006, issue
T. A. Steinberg, N. R. Ward
FLAME SPREADING AND VIOLENT ENERGY RELEASE PROCESS OF ALUMINUM TUBING IN LIQUID AND GASEOUS OXYGEN ENVIRONMENTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
J. G. Hansel, P. A. Houghton, M. M. Mench
EXPERIMENTAL ANALYSIS METHOD OF THE TRANSIENT BURNING RATE OF SOLID PROPELLANT UNDER RAPID PRESSURE CHANGES
International Journal of Energetic Materials and Chemical Propulsion, Vol.13, 2014, issue 5
Boris S. Jankovski, Vladica Bozic
AEROTHERMOCHEMICAL MODEL FOR THE INTERIOR BALLISTICS OF SOLID PROPELLANT ROCKET MOTORS
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
J. Perez, Rodrigo I. Caro, Juan de Dios Rivera
EXPERIMENTAL INVESTIGATION OF METALIZED SOLID FUEL RAMJET COMBUSTOR
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 2
Alon Gany, Shimon Saraf