Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
Computational Thermal Sciences: An International Journal
ESCI SJR: 0.249 SNIP: 0.434 CiteScore™: 1.4

ISSN Imprimir: 1940-2503
ISSN En Línea: 1940-2554

Computational Thermal Sciences: An International Journal

DOI: 10.1615/ComputThermalScien.2020018708
pages 207-215

USING STEAM COILS IN MARINE APPLICATIONS

Gavriil Gavriil
Department of Environmental & Natural Resources Management, University of Patras, G. Seferi 2, 30100, Agrinio, Greece
George N. Prodromidis
Department of Environmental & Natural Resources Management, University of Patras, G. Seferi 2, 30100, Agrinio, Greece
Frank A. Coutelieris
Department of Environmental & Natural Resources Management, University of Patras, G. Seferi 2, 30100, Agrinio, Greece

SINOPSIS

It is rather common practice for the marine industry to use water heating coils to heat heavy fuel oil. Obviously, the efficiency of the heat transfer process is strongly dependent on the dimensions of the coil (length, thickness, and diameter) as well as on the operational parameters (oil temperature, steam temperature, and steam pressure). In the present work, the heat transfer from superheated water at high temperature (~ 424 K) and fixed pressure (5 bar) to fuel oil tanks of specific dimensions was theoretically investigated by both a macroscopic thermo-dynamical approach and microscopic simulations (using the commercial CFD-ACE+ software package). Since the scope of this study was to estimate the necessary size and length under the assumption of an insulated tank, a parametric analysis was also performed in order to identify the relative influence of each parameter on the process performance.

REFERENCIAS

  1. Bejan, A., Heat Transfer, New York: Wiley, 1993.

  2. Cheng, L., Gu, H., and Huang, S., A Comprehensive Mathematical Model for Estimating Oil Drainage Rate in SAGD Process Considering Wellbore/Formation Coupling Effect, Heat Mass Transf., vol. 53, pp. 1777-1795, 2017.

  3. Dbouk, T., A Review about the Engineering Design of Optimal Heat Transfer Systems Using Topology Optimization, Appl. Therm. Eng., vol. 112, pp. 841-854, 2017.

  4. Dzida, M., On the Possible Increasing of Efficiency of Ship Power Plant with the System Combined of Marine Diesel Engine, Gas Turbine and Steam Turbine, at the Main Engine-Steam Turbine Mode of Cooperation Possible to be Further Utilized, is Emitted from the Engines, Pol. Marit. Res., vol. 16, pp. 47-52, 2009.

  5. Holman, J.P. Ed., Heat Transfer, New York: McGraw-Hill, 1990.

  6. MAN Diesel & Turbo, The MC Engine. Exhaust Gas Date. Waste Heat Recovery System. Total Economy, Copenhagen, Denmark: MAN B&W Publications S.A., 1985.

  7. Mcbride, B.J., Gordon, S., and Reno, M.A., Coefficient for Calculating Thermodynamic and Transport Properties of Individual Species, NASA Technical Memo TM-4513, Oct. 1993.

  8. Pang, Z., Wu, Z., and Zhao, M., A Novel Method to Calculate Consumption of Non-Condensate Gas during Steam Assistant Gravity Drainage in Heavy Oil Reservoirs, Energy, vol. 130, pp. 76-85, 2017.

  9. Perry, R.H. and Green, D.W., Perry's Chemical Engineers' Handbook, New York: McGraw-Hill, 1997.

  10. Rafiee, S.E. and Sadeghiazad, M.M., Experimental and 3D CFD Investigation on Heat Transfer and Energy Separation inside a Counter Flow Vortex Tube Using Different Shapes of Hot Control Valves, Appl. Therm. Eng., vol. 110, pp. 648-664, 2017.

  11. Sato, N. Ed., Chemical Energy and Exergy: An Introduction to Chemical Thermodynamics for Engineers, Amsterdam, Netherlands: Elsevier, 2004.

  12. Wagner, W. and Kretzschmar, H.-J. Eds., International Steam Tables, Properties of Water and Steam based on the Industrial Formulation, Berlin, Germany: Springer, 1998.


Articles with similar content:

EXPERIMENTAL STUDY AND NUMERICAL MODEL FOR A PHASE-CHANGE THERMAL ENERGY STORAGE UNIT
International Heat Transfer Conference 7, Vol.17, 1982, issue
D. Delaunay, J. Bransier, Jean Pierre Bardon
NUMERIC SIMULATION OF THE NATURAL CONVECTION IN A HORTICULTURAL GREENHOUSE HEATED FROM BELOW (BY THE USE OF THE CFD)
ICHMT DIGITAL LIBRARY ONLINE, Vol.11, 2004, issue
Draoui Belkacem, Nacima Tadj / wife Nahal
REAL EFFECTIVENESS OF VENTILATION AIR HEAT RECOVERY EQUIPMENT
Advances in Heat Transfer Engineering, Vol.1, 2003, issue
Egidijus Juodis
Numerical study of the influence of irregular fouling distributions inside the tubes of a power plant condenser
ICHMT DIGITAL LIBRARY ONLINE, Vol.2, 2004, issue
M. Manuela Prieto Gonzalez, Ines Suarez Ramon
PHASE CHANGE THERMAL STORAGE: HEAT TRANSFER ANALYSIS FOR A THERMODYNAMIC SYSTEMATLZATION
International Heat Transfer Conference 10, Vol.7, 1994, issue
M. Conti, C. Bellecci