Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
Journal of Enhanced Heat Transfer
Factor de Impacto: 0.562 Factor de Impacto de 5 años: 0.605 SJR: 0.175 SNIP: 0.361 CiteScore™: 0.33

ISSN Imprimir: 1065-5131
ISSN En Línea: 1026-5511

Volumes:
Volumen 27, 2020 Volumen 26, 2019 Volumen 25, 2018 Volumen 24, 2017 Volumen 23, 2016 Volumen 22, 2015 Volumen 21, 2014 Volumen 20, 2013 Volumen 19, 2012 Volumen 18, 2011 Volumen 17, 2010 Volumen 16, 2009 Volumen 15, 2008 Volumen 14, 2007 Volumen 13, 2006 Volumen 12, 2005 Volumen 11, 2004 Volumen 10, 2003 Volumen 9, 2002 Volumen 8, 2001 Volumen 7, 2000 Volumen 6, 1999 Volumen 5, 1998 Volumen 4, 1997 Volumen 3, 1996 Volumen 2, 1995 Volumen 1, 1994

Journal of Enhanced Heat Transfer

DOI: 10.1615/JEnhHeatTransf.v9.i2.20
pages 69-76

Forced Convective Boiling of a Flurocarbon Liquid in Reduced Size Channels – an Experimental Study

Hitoshi Miznuma
Toshiba Electronics, Taiwan
Masud Behnia
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney 2052, Australia
Wataru Nakayama
Tokyo Institute of Technology, 2-12-1 Oh-Okayama, Meguro-ku Tokyo 152, Japan

SINOPSIS

The present paper reports the results of an experimental study of forced convection boiling heat transfer from a 2 cm × 2 cm simulated chip to a fluorocarbon coolant (FX-3250) in a parallel-plate channel. The experimental parameters were the channel height (1 and 5 mm), the surface geometry of the simulated chip (flat and microfilmed), and the coolant velocity (0.125−4 m/s). Longitudinal microfins (0.5 mm high x 0.5 mm wide) on the finned chip increased the actual surface area to about twice that of the flat surface.
Attention was focused on the data of the 1-mm high channel. When compared with the flat chip data on the footprint area basis, the microfins produced 40% of heat transfer enhancement at coolant velocities less than 1 m/s; however, the enhancement diminishes at higher velocities. The boiling curves of the finned chip, based on the actual area, seem to reflect that there is an effect due to the bypassing of flow through the cross-section over the fins. For both the flat chip and the finned chip there are crisis points where the two-phase flow becomes unstable at low coolant velocities. The practice of degassing produced negligible effects on boiling heat transfer in the 1-mm high channel.