Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.9

ISSN Druckformat: 2152-5102
ISSN Online: 2152-5110

Volumes:
Volumen 47, 2020 Volumen 46, 2019 Volumen 45, 2018 Volumen 44, 2017 Volumen 43, 2016 Volumen 42, 2015 Volumen 41, 2014 Volumen 40, 2013 Volumen 39, 2012 Volumen 38, 2011 Volumen 37, 2010 Volumen 36, 2009 Volumen 35, 2008 Volumen 34, 2007 Volumen 33, 2006 Volumen 32, 2005 Volumen 31, 2004 Volumen 30, 2003 Volumen 29, 2002 Volumen 28, 2001 Volumen 27, 2000 Volumen 26, 1999 Volumen 25, 1998 Volumen 24, 1997 Volumen 23, 1996 Volumen 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v25.i1-3.80
pages 86-97

An Experimental Study of Forced Convective Boiling Heat Transfer of Refrigerants in a Rough Surface Tube

Satoru Momoki
Department of Mechanical Systems Engineering, Nagasaki University, Nagasaki, Japan
H. Shintaku
Institute of Advanced Material Study, Kyushu University, Kasuga, Japan
Jian Yu
Institute of Advanced Material Study, Kyushu University, Kasuga, 816, Japan
Shigeru Koyama
International Institute for Carbon-Neutral Energy Research (WPI-I2CNER), Kyushu University, 744 Motooka, Nishi-ku, Fukuoka 819-0395, Japan; Interdisciplinary Graduate School of Engineering Sciences, Kyushu University, Kasuga-koen 6-1, Kasuga-shi, Fukuoka 816-8580, Japan
Toru Shigechi
Department of Mechanical Systems Engineering, Nagasaki University, Nagasaki, Japan
T. Fujii
Institute of Advanced Material Study, Kyushu University, Kasuga, Japan

ABSTRAKT

Experiments were carried out on the forced convective boiling heat transfer of refrigerants HCFC22 and HCFC123 inside a tube whose surface was rougher than that of an ordinary smooth copper tube used commercially as heat transfer tube. The local heat transfer coefficients were measured in the range of reduced pressure ratio of 0.07 to 0.23 for mass velocity 300 kg/(m2·s). The measured heat transfer coefficients inside the present tube in annular flow regime are 20−80% higher than those calculated using the authors' previous correlation for an ordinary smooth tube. Once the term representing the nucleate pool boiling heat transfer contribution in this correlation equation is modified by considering the surface roughness effect, the modified equation can correlate the heat transfer coefficients of the present tube within 25% deviations.


Articles with similar content:

COMPARISON OF EVAPORATION PRESSURE DROP CHARACTERISTICS IN HORIZONTAL THREE-DIMENSIONAL ENHANCED TUBES
International Heat Transfer Conference 16, Vol.14, 2018, issue
Yan He, S.A. Sherif, Xiang Ma, Wei Li, Weiyu Tang
Convective Vaporization of Pure Refrigerants in Enhanced and Integral-Fin Tube Banks
Journal of Enhanced Heat Transfer, Vol.1, 1994, issue 4
Neelkanth S. Gupte, Ralph L. Webb
Evaporation heat transfer characteristics of low GWP refrigerants
Second Thermal and Fluids Engineering Conference, Vol.20, 2017, issue
Minsoo Kim, Keumnam Cho
Heat Transfer During Film Condensation of R-123 Vapour on Horizontal Integral-Fin Tubes
Journal of Enhanced Heat Transfer, Vol.3, 1996, issue 2
S. P. Sukhatme, L. K. Sreepathi, S. L. Bapat
CONVECTIVE BOILING HEAT TRANSFER OF WATER IN A CAPILLARY TUBE UNDER A LOW FLOW RATE CONDITION
International Heat Transfer Conference 13, Vol.0, 2006, issue
Fumito Kaminaga, Kunihito Matsumura, Sumith Baduge