Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.5

ISSN Druckformat: 2152-5102
ISSN Online: 2152-5110

Volumes:
Volumen 46, 2019 Volumen 45, 2018 Volumen 44, 2017 Volumen 43, 2016 Volumen 42, 2015 Volumen 41, 2014 Volumen 40, 2013 Volumen 39, 2012 Volumen 38, 2011 Volumen 37, 2010 Volumen 36, 2009 Volumen 35, 2008 Volumen 34, 2007 Volumen 33, 2006 Volumen 32, 2005 Volumen 31, 2004 Volumen 30, 2003 Volumen 29, 2002 Volumen 28, 2001 Volumen 27, 2000 Volumen 26, 1999 Volumen 25, 1998 Volumen 24, 1997 Volumen 23, 1996 Volumen 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v25.i4-6.270
pages 753-762

The Use of Temperature Transients to Calculate the Thermal Diffusivity in Powders

Joe Deans
Department of Mechanical Engineering, University of Auckland, Auckland, New Zealand
J. Morrison
Department of Mechanical Engineering, University of Auckland, New Zealand
M. Alien
Department of Mechanical Engineering, University of Auckland, New Zealand

ABSTRAKT

This paper describes the development of a quick and simple method which can be used to measure the thermal diffusivity of fine powders. The method is based on measuring and analyzing the phase lag which evolves in a cylindrical sample of powder subjected to an oscillating temperature wave originating at its axis. The variation of this phase lag with frequency has been analyzed using both an analytical solution and a finite difference model. The analytical solution is the quicker method but the finite difference method is considered to be the more accurate. There is, however good agreement in the values found from both solutions. These solutions were applied to the results obtained from tests on three powders and then-apparent Thermal Diffusivities are close to those predicted using other methods. As a comparison a test was performed and analyzed with the rig filled with paraffin wax and the value obtained is close to that published in the literature.


Articles with similar content:

THE USE OF TEMPERATURE TRANSIENTS TO CALCULATE THE THERMAL DIFFUSIVITY IN POWDERS
Transport Phenomena in Thermal Engineering. Volume 2, Vol.0, 1993, issue
J. Morrison, Joe Deans, M. Allen
HEAT TRANSFER IN FIXED BEDS OF PARTICLES AT LOW AND INTERMEDIATE REYNOLDS NUMBERS
International Heat Transfer Conference 6, Vol.4, 1978, issue
A.P. Wardle, D. J. Gunn, P.V. Narayanan
TRANSIENT RESPONSE OF A COMPOSITE HOLLOW CYLINDER HEATED BY A MOVING LINE SOURCE WITH HYPERBOLIC HEAT CONDUCTION EQUATION
International Heat Transfer Conference 8, Vol.2, 1986, issue
J. H. Tzou, H. S. Chu, J. M. Chen
Entropy Generation for Pulsating Flow in a Composite Fluid/Porous System
Journal of Porous Media, Vol.11, 2008, issue 6
Dhahri Hacen, Sassi Ben Nasrallah, Khalifa Slimi
New Estimation Method Based on Integral Transforms for the Thermal Diffusivity Measurement of Anisotropic Materials
International Heat Transfer Conference 15, Vol.28, 2014, issue
Benjamin Remy, Alain Degiovanni, Mathieu Niezgoda, Christophe Rodiet