Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.5

ISSN Druckformat: 2152-5102
ISSN Online: 2152-5110

Volumes:
Volumen 46, 2019 Volumen 45, 2018 Volumen 44, 2017 Volumen 43, 2016 Volumen 42, 2015 Volumen 41, 2014 Volumen 40, 2013 Volumen 39, 2012 Volumen 38, 2011 Volumen 37, 2010 Volumen 36, 2009 Volumen 35, 2008 Volumen 34, 2007 Volumen 33, 2006 Volumen 32, 2005 Volumen 31, 2004 Volumen 30, 2003 Volumen 29, 2002 Volumen 28, 2001 Volumen 27, 2000 Volumen 26, 1999 Volumen 25, 1998 Volumen 24, 1997 Volumen 23, 1996 Volumen 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v25.i4-6.150
pages 614-621

Boiling Characteristics of Subcooled Liquid Flowing through Microchannels

Bu-Xuan Wang
Laboratory of Phase Change and Interfacial Transport Phenomena, Department of Thermal Engineering, Tsinghua University, Beijing 100084, China
Professor Wang has been an influential educator of thermal engineering in China. He established firstly a new speciality â Engineering Thermophysics in Tsinghua University in 1957. Professor Wang was a founding member of the Chinese Society of Engineering Thermophysics. He was appointed by the State Education Commission as Chairman of the Committee for Basic Engineering Teaching on Thermodynamics & Heat Transfer in Colleges and Universities during 1979-1995, and as a leading member of the evolving section Power Engineering & Engineering Thermophysics of National Degree Committee from 1981-1997. Professor Wang's research, a number of projects he undertook were prompted by national needs. For example, from 1963 to 1966, he led a research team seeking to accelerate the synthesis of ammonia in a large Sichuan chemical plant by enhancing heat transfer through a resign of compact heat exchanger within a tower so as to provide more effective catalystic volume and to obtain a more favorable temperature distribution in the piled catalyst. The efforts resulted in a doubling of the daily production, which is listed in the State Conncil's Government Bulletin of 1966 as one of the hundred important achievements.
Xiao-Feng Peng
Laboratory of Phase Change and Interfacial Transport Phenomena, Department of Thermal Engineering, Tsinghua University, Beijing 100084

ABSTRAKT

Experiments were conducted to investigate the forced-flow boiling characteristics of subcooled liquid flowing through microchannels with cross-section of 0.6×0.7 mm, machined on the stainless steel plate 2 mm thick. The influences of liquid velocity and subcooling on the boiling curve were experimentally inspected. The experiments indicated that the flow boiling characteristics are quite different from that in normally sized tubes. The flow boiling heat transfer was intensified greatly, and there did not exist the apparent partial nucleate boiling for subcooled flow boiling, i.e., boiling was induced much earlier in micro-channels.


Articles with similar content:

Cooling Characteristics with Microchanneled Structures
Journal of Enhanced Heat Transfer, Vol.1, 1994, issue 4
Bu-Xuan Wang, Xiao-Feng Peng
CRITICAL HEAT FLUX AND FLOW CHARACTERISTICS OF SUBCOOLED FLOW BOILING WITH WATER IN NARROW TUBES
Dynamics of Two-Phase Flows, Vol.1, 1988, issue
F. Inasaka, Hideki Nariai
FORCED CONVECTIVE SUBCOOLED BOILING HEAT TRANSFER AND CHF IN SMALL-DIAMETER TUBES
International Heat Transfer Conference 9, Vol.2, 1990, issue
S. Hosaka, Masaru Hirata, Nobuhide Kasagi
BOILING HEAT TRANSFER CHARACTERISTICS FROM VERY SMALL HEATERS ON A SUBSTRATE
International Heat Transfer Conference 10, Vol.12, 1994, issue
Kazuyoshi Fushinobu, Tadashi Saitoh, T. Nagasaki, Atsushi Ui, Kunio Hijikata
HEAT TRANSFER OF DEVELOPING FLOW IN THE TRANSITIONAL FLOW REGIME
First Thermal and Fluids Engineering Summer Conference, Vol.7, 2015, issue
Josua Petrus Meyer, Marilize Everts