Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.5

ISSN Druckformat: 2152-5102
ISSN Online: 2152-5110

Volumes:
Volumen 46, 2019 Volumen 45, 2018 Volumen 44, 2017 Volumen 43, 2016 Volumen 42, 2015 Volumen 41, 2014 Volumen 40, 2013 Volumen 39, 2012 Volumen 38, 2011 Volumen 37, 2010 Volumen 36, 2009 Volumen 35, 2008 Volumen 34, 2007 Volumen 33, 2006 Volumen 32, 2005 Volumen 31, 2004 Volumen 30, 2003 Volumen 29, 2002 Volumen 28, 2001 Volumen 27, 2000 Volumen 26, 1999 Volumen 25, 1998 Volumen 24, 1997 Volumen 23, 1996 Volumen 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v25.i4-6.350
pages 833-843

Splash-Zone Heat Transfer in Bubbling Fluidized Beds: an Experimental Study of Temperature Effects

David Pidwerbecki
Department of Mechanical Engineering, Oregon State University, Corvallis, OR 97331, USA
James R. Welty
Department Mechanical Engineering, Oregon State University, 204 Rogers Hall, Corvallis, Oregon - 97331, USA

ABSTRAKT

Experimental results are reported for the heat transfer between a high temperature fluidized bed and a horizontal tube located within the splash-zone. Of specific interest in this study is the effect of bed temperature. Four bed operating temperatures, 700 K, 810 K, 908 K, and 1003 K, were investigated. At each temperature, five circumferential local time averaged values of the total and radiative heat transfer coefficients were measured for three tube locations. The tube was located at 406 mm, 64 mm, and -133 mm relative to the packed bed-freeboard interface. These locations are representative of a tube in the freeboard, splash-zone, and totally immersed in the bed, respectively. The tube outside diameter was 51 mm, the mean bed particle size was 2.9 mm, and the fluidizing velocity varied from near minimum fluidization conditions (Umf) to over 1.5 Umf. The work was performed in the Oregon State University high temperature fluid-ized-bed test facility.


Articles with similar content:

SPLASH-ZONE HEAT TRANSFER IN BUBBLING FLUIDIZED BEDS: AN EXPERIMENTAL STUDY OF TEMPERATURE EFFECTS
Transport Phenomena in Thermal Engineering. Volume 2, Vol.0, 1993, issue
James R. Welty, David Pidwerbecki
EXPERIMENTAL STUDIES OF HEAT TRANSFER FROM AN ATMOSPHERIC-FLU ID I ZED-BED COMBUSTOR TO AN IMMERSED ARRAY OF HORIZONTAL TUBES
International Heat Transfer Conference 7, Vol.15, 1982, issue
N. S. Grewal, D. R. Hajicek
INCOMPLETE SIMILARITY OF A PLANE TURBULENT WALL JET
TSFP DIGITAL LIBRARY ONLINE, Vol.7, 2011, issue
Donald J. Bergstrom, James D. Bugg, Noorallah Rostamy, David Sumner
HEAT TRANSFER DURING TRANSIENT COOLING OF HIGH TEMPERATURE SURFACE WITH AN IMPINGING JET
Multiphase Science and Technology, Vol.12, 2000, issue 3&4
Yuichi Mitsutake, Masanori Monde
MEASUREMENTS OF INSTANTANEOUS LOCAL HEAT TRANSFER COEFFICIENTS AROUND A TUBE IMMERSED IN A HIGH TEMPERATURE FLUIDIZED BED
International Heat Transfer Conference 10, Vol.4, 1994, issue
Ulrich Renz, Heinz Jorg Rottger