Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.9

ISSN Druckformat: 2152-5102
ISSN Online: 2152-5110

Volumes:
Volumen 47, 2020 Volumen 46, 2019 Volumen 45, 2018 Volumen 44, 2017 Volumen 43, 2016 Volumen 42, 2015 Volumen 41, 2014 Volumen 40, 2013 Volumen 39, 2012 Volumen 38, 2011 Volumen 37, 2010 Volumen 36, 2009 Volumen 35, 2008 Volumen 34, 2007 Volumen 33, 2006 Volumen 32, 2005 Volumen 31, 2004 Volumen 30, 2003 Volumen 29, 2002 Volumen 28, 2001 Volumen 27, 2000 Volumen 26, 1999 Volumen 25, 1998 Volumen 24, 1997 Volumen 23, 1996 Volumen 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v24.i4-6.420
pages 872-883

Time Dividing Analysis of Intermittent Fuel Spray Flows Measured by PDA

Tsuneaki Ishima
Department of Mechanical System Engineering, Gunma University, 1-5-1, Tenjin, Kiryu, 376 Japan
W.-Q. Long
Mechanical Engineering Laboratory, MITI, Tsukuba, Japan
T. Obokata
Department of Mechanical System Engineering, Gunma University, 1-5-1, Tenjin, Kiryu, 376 Japan

ABSTRAKT

The article presents the analyzing methods for intermittent and cyclic Diesel type- and gasoline type-sprays. The Diesel type sprays were initiated from a single-hole, a four-holes and a conical spray nozzles, and the gasoline type spray was initiated from an air-assisted spray injector. The measurements have been carried out by using phase Doppler anemometer (PDA). A frequency discriminating center part selection method and a temporal dividing method have been proposed for evaluating the intermittent cyclic spray. Using the frequency discrimination method, it was easy to discuss the intermittent spray characteristics with the mean velocity and the velocity fluctuation, and it was also easy to compare the results between those of continuous sprays and/or gas jets. The temporal dividing method was able to explain unusual correlations between droplet size and velocity of the intermittent sprays from both the conical nozzle and the air assisted injector. An accumulation of large particle was observed by using this method in the conical spray.


Articles with similar content:

DEVELOPMENT OF PSEUDO-HIGH SPEED IMAGE PHOTOGRAPHIC SYSTEM AND THEIR APPLICATION TO DIESEL SPRAYS
ICLASS 94
Proceedings of the Sixth International Conference on Liquid Atomization and Spray Systems, Vol.0, 1994, issue
N. Shimazaki, G. Ogihara, M. Nakayama
Characterization of Direct-Injection Gasoline Sprays under Different Ambient and Fuel Injection Conditions
International Journal of Fluid Mechanics Research, Vol.24, 1997, issue 4-6
J.-H. Yoo, Fu-Quan Zhao, K.-S. Lee, Ming Chia Lai, Y. Liu
CHARACTERISTICS OF THE SPRAY PRODUCED BY THE ATOMIZATION OF AN ANNULAR LIQUID SHEET ASSISTED BY AN INNER GAS JET
Atomization and Sprays, Vol.22, 2012, issue 6
Nicolas Leboucher, Francis Roger, Jean-Louis Carreau
AUTOIGNITION CHARACTERISTICS OF DIESEL SPRAYS UNDER DIFFERENT INJECTION CONDITIONS
Atomization and Sprays, Vol.6, 1996, issue 4
Raffaele Ragucci, Antonio Cavaliere, C. Noviello
DROPLET SIZE AND VELOCITY MEASUREMENTS IN A CRYOGENIC JET FLAME OF A ROCKET-TYPE COMBUSTOR USING HIGH-SPEED IMAGING
Atomization and Sprays, Vol.26, 2016, issue 5
Yves Le Sant, Arnaud Ristori, Lucien Vingert, Nicolas Fdida