Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
Computational Thermal Sciences: An International Journal
ESCI SJR: 0.249 SNIP: 0.434 CiteScore™: 1.4

ISSN Druckformat: 1940-2503
ISSN Online: 1940-2554

Computational Thermal Sciences: An International Journal

DOI: 10.1615/ComputThermalScien.2016014791
pages 385-404

HEAT TRANSFER IN NATURAL CONVECTION WITH FINITE-SIZED PARTICLES CONSIDERING THERMAL CONDUCTANCE DUE TO INTER-PARTICLE CONTACTS

Shintaro Takeuchi
Department of Mechanical Engineering, Osaka University, 2-1 Yamada-oka, Suita-city, Osaka 565-0871 Japan
Takaaki Tsutsumi
Department of Mechanical Engineering, Osaka University, 2-1 Yamada-oka, Suita-city, Osaka 565-0871 Japan
Katsuya Kondo
Department of Mechanical Engineering, Osaka University, 2-1 Yamada-oka, Suita-city, Osaka 565-0871 Japan; Tottori University, 4-101 Koyama-Minami, Tottori, 680-8552 Japan
Takeshi Harada
Department of Mechanical Engineering, Osaka University, 2-1 Yamada-oka, Suita-city, Osaka 565-0871 Japan
Takeo Kajishima
Department of Mechanical Engineering, Osaka University, 2-1 Yamada-oka, Suita-city, Osaka 565-0871 Japan

ABSTRAKT

The heat transfer problem in solid-dispersed two-phase flow is numerically studied. Temperature gradient within the finite-sized particles and inter-particle heat flux due to collisions are considered, and those effects on the flow structure and heat transfer are discussed. The interaction between fluid and particles is treated by our original immersed solid approach. For the conjugate heat transfer problems, to satisfy the thermal condition at the fluid-solid interface, our interfacial heat flux model is employed. Also, the interfacial flux model is extended to incorporate the heat conduction due to inter-particle contacts, based on 2D and axisymmetric contact heat resistance solutions. The method is applied to 2D and 3D natural convection problems including multiple particles in a confined domain under relatively low Rayleigh numbers (104−106). Heat transfer and particle behaviors are studied for different solid volume fractions (up to about 50%) and heat conductivity ratios (solid to fluid) ranging between 10−3 and 103. Under high solid volume fraction conditions, the particles are observed to form densely concentrated regions, where heat flow tends to channel through the contacting points. In three-dimensional solid-dispersed flows, by decomposing the heat flux into the contributions of the convection and conduction, the change of the major heat transfer mode is studied for different solid volume fractions and conductivity ratios.


Articles with similar content:

Heat transfer in particle-dispersed two phase flows considering temperature gradient within the particles
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2015, issue
Shintaro Takeuchi, Takaaki Tsutsumi, Takeo Kajishima
REITERATED HOMOGENIZATION APPLIED TO NANOFLUIDS WITH AN INTERFACIAL THERMAL RESISTANCE
International Journal for Multiscale Computational Engineering, Vol.18, 2020, issue 3
Federico J. Sabina, Ernesto Iglesias-Rodríguez, Manuel Ernani C. Cruz, Leslie D. Pérez-Fernández, Julián Bravo-Castillero
LATTICE BOLTZMANN SIMULATION OF EFFECTIVE THERMAL CONDUCTIVITY OF POROUS MEDIA WITH MULTIPHASE
Journal of Porous Media, Vol.18, 2015, issue 10
Zhichun Liu, Jun Shen, Wei Liu, Dongdong Wang
NUMERICAL INVESTIGATION OF HEAT AND MASS TRANSFER IN A STRUCTURED PACKED BED OF POROUS SPHERICAL PARTICLES
International Heat Transfer Conference 16, Vol.21, 2018, issue
Wojciech Lipinski, Vincent M. Wheeler, Morteza Hangi
FILM FLOW AND HEAT TRANSFER ON A VERTICALLY GROOVED SURFACE
International Heat Transfer Conference 7, Vol.11, 1982, issue
David Moalem-Maron , Samuel Sideman, A. Levin