Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN Druckformat: 2150-766X
ISSN Online: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v5.i1-6.420
pages 384-396

FLAME SPREADING AND VIOLENT ENERGY RELEASE PROCESS OF ALUMINUM TUBING IN LIQUID AND GASEOUS OXYGEN ENVIRONMENTS

M. M. Mench
Department of Mechanical Engineering, The Pennsylvania State University, University Park, PA 16802, U.S.A.
P. A. Houghton
Department of Mechanical and Nuclear Engineering, The Pennsylvania State University, University Park, PA 16802, USA
J. G. Hansel
Air Products and Chemicals, Inc. Allentown, PA 18195-1501, USA

ABSTRAKT

The intense reaction observed between aluminum and oxygen in a liquid oxygen (LOX) environment has been termed a violent energy release (VER) reaction, but the details of the combustion process are not fully understood. In this study, the promoted ignition, flame spreading, and combustion phenomena of aluminum 3003 alloy tubing filled with LOX, surrounded by a shell of gaseous oxygen (GOX), were observed. Parameters that were systematically varied include the tube- and shell-side GOX and LOX pressures, flow rates, oxygen purities, as well as igniter location, tube-side GOX quality, and sample thickness. An extremely high flame spreading rate, a high luminosity flame-zone, and a very rapid rate of heat release characterize the VER burning mode. The effect of tube- or shell-side impurity is to raise the threshold pressure for self-sustained combustion and VER transition. Decreased wall thickness tends to lower the threshold pressure for self-sustained combustion and transition to VER. It is believed that the VER flame-spreading mode is primarily a result of high convective mass flux of oxygen into the reaction zone due to oxygen phase transition; this process greatly enhances both the reaction rate and the molten material removal rate.


Articles with similar content:

COMBUSTION AND FLAME SPREADING OF ALUMINUM TUBING IN HIGH PRESSURE OXYGEN
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
J. P. Haas, M. M. Mench
FORMATION OF CONSOLIDATED NANOTHERMITE MATERIALS USING SUPPORT SUBSTRATES AND/OR BINDER MATERIALS
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 5
Chris J. Bulian, Jacek J. Swiatkiewicz, Deepak Kapoor, Jan A. Puszynski
EFFECT OF AZODICARBONAMIDE PARTICLES ON THE REGRESSION RATE OF HYDROXYL-TERMINATED POLYBUTADIENE (HTPB)-BASED FUELS FOR HYBRID ROCKET PROPULSION
International Journal of Energetic Materials and Chemical Propulsion, Vol.16, 2017, issue 2
Luigi T. DeLuca, Ruiqi Shen, Suhang Chen, Yinghua Ye, Yue Tang, Wei Zhang
AN EXPERIMENTAL INVESTIGATION OF EXPEDITED UNIDIRECTIONAL FREEZING OF NANOPARTICLE-ENHANCED PHASE CHANGE MATERIALS (NEPCM)
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2011, issue
Jay M. Khodadadi, Liwu Fan
ANALYSIS OF QUASI-STEADY AND TRANSIENT BURNING OF HYBRID FUELS IN A LABORATORY-SCALE BURNER BY AN OPTICAL TECHNIQUE
International Journal of Energetic Materials and Chemical Propulsion, Vol.12, 2013, issue 5
G. Rambaldi, M. Manzoni, Christian Paravan, Luigi T. De Luca