Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.142 SNIP: 0.16 CiteScore™: 0.29

ISSN Druckformat: 2150-766X
ISSN Online: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.2013007306
pages 537-547

MELT CAST EXPLOSIVE FRIABILITY STUDIES

Alice I. Atwood
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100 USA
Kevin P. Ford
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100
M. T. Gennrich
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100
Q. T. BuiDang
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100
C. J. Wheeler
Naval Air Warfare Center Weapons Division (NAWCWD), China Lake, California 93555-6100, USA
E. Woods
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100
A. L. Daniels
Naval Air Warfare Center Weapons Division, China Lake, CA 93555-6100

ABSTRAKT

The combustion and friability behavior of two melt cast explosives, designated MC1 and MC2, are under investigation. The burning rate of the MC1 explosive appears to be controlled by the nitramine contained in the formulation. The second melt cast explosive, MC2, contains a high level of dense inert metal that acts to decrease or quench the burning rates at pressure below 27 MPa and would not sustain combustion at pressures below 6.9 MPa under the conditions of the experiment. Cylindrical samples of the melt cast explosives were impact damaged at velocities from 19.5 to 131.7 m/s. Damage levels in the MC2 explosive were about two orders of magnitude greater than for the MC1 explosive.


Articles with similar content:

ELECTROLYTIC-INDUCED DECOMPOSITION AND IGNITION OF HAN-BASED LIQUID MONOPROPELLANTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.6, 2007, issue 5
Grant A. Risha, Vigor Yang, Richard A. Yetter
EXAMINATION OF AP/KN COMPOSITE PROPELLANT THERMAL WAVE STRUCTURE UNDER STEADY-STATE BURNING
International Journal of Energetic Materials and Chemical Propulsion, Vol.6, 2007, issue 2
D. D. Blagojevic, Boris S. Jankovski, Marko V. Milos, Vladica Bozic
BEHAVIOR OF HYDROXYL-TERMINATED POLYETHER (HTPE) COMPOSITE ROCKET PROPELLANTS IN SLOW COOK-OFF
International Journal of Energetic Materials and Chemical Propulsion, Vol.7, 2008, issue 3
Rodrigo I. Caro, John M. Bellerby
THERMAL ANALYSIS OF IRON RODS BURNING IN NORMAL-GRAVITY AND REDUCED-GRAVITY
International Heat Transfer Conference 13, Vol.0, 2006, issue
T. A. Steinberg, N. R. Ward
PREDICTION MODEL AND VERIFICATION OF EXPLOSIVE IGNITION IN EXPLODING FOIL INITIATOR SYSTEM
Second Thermal and Fluids Engineering Conference, Vol.2, 2017, issue
Kyu-Hyoung Kim, Kyoungjin Kim, Seung-gyo Jang