图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
国际流体力学研究期刊
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.5

ISSN 打印: 2152-5102
ISSN 在线: 2152-5110

国际流体力学研究期刊

DOI: 10.1615/InterJFluidMechRes.v25.i4-6.210
pages 689-698

Heat Transfer Characteristics of a Finned Horizontal Tube in a FBC

Tae Yong Chung
Department of Mechanical Engineering, Kookmin University, Seoul 132-720, KOREA
Jae Ou Chae
Department of Mechanical Engineering, Inha University, Inchon 420-020, KOREA
Pyung Sam Ji
New Energy Section, Power Generation Department, Research Center, KEPCO, 117-15, Yongjeon-Dong, Dong-ku, Taejon 300-200, KOREA

ABSTRACT

This study is to investigate the characteristics of heat transfer of a horizontal tube, equipped with radial fins of triangular profile, immersed in a high-temperature fluidized bed. The heat transfer variations are compared with those of a smooth tube experimentally.
The finned tubes and smooth tube, with outside and inside diameters of 48.6 mm and 30.6 mm, are made of steel. The depth of the fin is 5 mm and the angles of fin are 25°, 30°, 35°, 40°, 45°, and 50°. Experiments are conducted at three different bed temperatures of 720, 800 and 880°C. A granular refractory (silica sand) is used as bed material with mean particle diameters of 0.96 mm and 1.37 mm.
The maximum heat transfer coefficient is achieved by the rake angle of 25° for the particle size 0.96 mm of bed material, and by the rake angle of 30° for the particle size 1.37 min. These coefficients are about 2 and 1.8 times higher than the case for the smooth tube, respectively. The heat transfer coefficient for the finned tube is greater than that for the smooth tube. Also the rake angle of the finned tube for the maximum heat transfer coefficient changes depending on the particle size of bed material, and the effect of the rake angle becomes more distinct as the bed temperature increases.


Articles with similar content:

HEAT TRANSFER CHARACTERISTICS OF A FINNED HORIZONTAL TUBE IN A FBC
Transport Phenomena in Thermal Engineering. Volume 2, Vol.0, 1993, issue
Jae Ou Chae, Tae Yong Chung, Pyung Sam Ji
DEPOSITION OF AIRBORNE PARTICLES ONTO THE SURFACES OF AIR-COOLED FINNED TUBE
International Heat Transfer Conference 7, Vol.16, 1982, issue
M.S. El-Shobokshy , K.E. El-Zayat
HEAT TRANSFER BETWEEN A PRESSURIZED GAS-SOLID SUSPENSION AND IMMERSED SURFACES
International Heat Transfer Conference 9, Vol.5, 1990, issue
P. Rantanen , N.-E. Fagerholm, P. Kukkonen
FILM CONDENSATION OF STEAM ON HORIZONTAL FINNED TUBES: EFFECT OF FIN SHAPE
International Heat Transfer Conference 8, Vol.4, 1986, issue
A. S. Wanniarachchi , John W. Rose, E. Mltrou, Paul J. Marto
EFFECT OF GEOMETRY AND WALL THICKNESS ON HEAT TRANSFER FROM LONGITUDINAL FINS TO BOILING LIQUIDS
International Heat Transfer Conference 5, Vol.6, 1974, issue
Chien-Cheng Shih, J. W. Westwater