图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
传热学
影响因子: 0.404 5年影响因子: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN 打印: 1064-2285
ISSN 在线: 2162-6561

传热学

DOI: 10.1615/HeatTransRes.2018021461
pages 865-880

EXPERIMENTAL STUDY OF ADIABATIC COOLING EFFECTIVENESS ON AN EFFUSION COOLED TEST PLATE WITH MACHINED RING GEOMETRIES

Jesuraj Felix
CSIR-National Aerospace Laboratories, Bangalore, Karnataka, India
Raghavan Rajendran
CSIR-National Aerospace Laboratories, Bangalore, Karnataka, India
Gottekre Narayanappa Kumar
Department of Mechanical Engineering, NITK, Surathkal, India
Yepuri Giridhara Babu
CSIR-National Aerospace Laboratories, Bangalore, Karnataka, India

ABSTRACT

The present study deals with experimental investigation of adiabatic cooling effectiveness on an effusion cooled test plate with machined ring geometries. Initial tests were performed on an effusion cooling holes. The cooling effectiveness at the beginning of effusion holes is lower, and it increases in the flow direction mainly due to the additive effect of film cooling effectiveness of the effusion cooling geometry. Subsequent tests were done with machined ring geometries fixed ahead of effusion cooling hole geometry to improve the cooling effectiveness before the beginning of effusion cooling holes. These machined ring geometries act as a wall jet and reduce the hot side heat load by film cooling performance. Tests were performed at a coolant to mainstream density ratio of 1.3 and at blowing ratios ranging from 0.5 to 2.5. Increase in the blowing ratio shows an increase in the cooling effectiveness. Comparison results show that the adiabatic cooling effectiveness increases significantly before the effusion cooling holes in the presence of machined ring geometries at all blowing ratios.


Articles with similar content:

FILM TEMPERATURE AND EFFECTIVENESS MEASUREMENTS ON A CYLINDRICAL LEADING EDGE FILM COOLING MODEL
International Heat Transfer Conference 11, Vol.18, 1998, issue
Shuye Teng, Je-Chin Han, Dong Kee Sohn
FILM COOLING EFFECT OF THE LEAKAGE THROUGH THE SEAM OF ADJACENT TURBINE BLADE PLATFORMS
International Heat Transfer Conference 13, Vol.0, 2006, issue
M. Y. Jabbari, E. J. Thor, Richard J. Goldstein
HEAT TRANSFER ENHANCEMENT IN A MODEL OF A BLADE COOLING PASSAGE USING COMBINATIONS OF RIBS AND RIB-GROOVES WITH FILM COOLING HOLES
Transport Phenomena in Thermal Engineering. Volume 2, Vol.0, 1993, issue
Peter T. Ireland, Jiarei Shen , T. V. Jones, Z. Wang
EFFECTS OF HOLE GEOMETRY ON HEAT (MASS) TRANSFER AND FILM COOLING EFFECTIVENESS
International Heat Transfer Conference 11, Vol.18, 1998, issue
Dong Ho Rhee, Hyung-Hee Cho, Byunggu Kim
VISUALIZATION OF LOCAL HEAT TRANSFER IN A PIN FIN CHANNEL WITH LIQUID CRYSTALS
Journal of Flow Visualization and Image Processing, Vol.2, 1995, issue 3
S. A. Hippensteele, S. C. Lau, L. M. Russell, D. R. Thurman